The Influence of Larch Lumber Drying Technology on the Duration of Dehydration
Journal Title: Lesnoy Zhurnal (Russian Forestry Journal) - Year 2020, Vol 13, Issue 4
Abstract
Convective drying of lumber should be considered as a relatively simple method of elimination moisture from wood. Such technologies are widely used in bringing moisture content in lumber to a certain level. Meanwhile, this drying method is characterized by an increased duration of the process, which automatically increases the expenses for thermal and electrical energy. The drying time of larch lumber is on average higher by 1.5–2.5 times compared to other species, which further increases the cost of drying. Therefore, there is a necessity of finding ways to solve the problem of reducing the drying time of larch lumber in the conditions of convective heat exchange. One of the ways is to develop and apply such drying schedules, which would allow to accelerate the process of wood dehydration. The option of improvement the drying schedules is offered by the Finnish experts of Jartek Oy company. The developed design of the drying kiln allows to implement a two-stage structure of drying schedules: at the first stage with increasing temperature, at the second with decreasing temperature. This paper presents the results of the analysis of the operation of continuous drying kilns with zonal circulation for larch lumber drying. The analysis showed that the direction of drying agent movement along the length of the kiln during larch lumber drying is critical. This conclusion follows from the fact that larch responses in a peculiar way to temperature variations. In the initial period of drying a film of extractives is formed on the surface of the larch вoard. This film blocks the output of an aqueous solution of extractives from wood. In these circumstances, it is advisable to form such schedules that the drying agent temperature with each step of a lumber pile in the drying kiln increases. The specified principle condition for drying larch lumber is observed only in the kiln section, where counter-flow circulation is carried out. The second section, where the direct-flow circulation is implemented, practically runs idle, since the drying agent temperature with each step of the drying pile of lumber decreases. It follows that such designs of kilns for larch lumber drying is impractical for operation.
Authors and Affiliations
Sh. G. Zaripov, V. A. Kornienko
Keywords
Related Articles
- EP ID EP688515
- DOI 10.37482/0536-1036-2020-4-134-146
- Views 217
- Downloads 0
Variability in Traits of Gmelin Larch Generative Organs in Eastern Transbaikalia
Forest vegetation in Zabaykalsky Krai covers 86.6 % of the total area. The dominant forest species is Gmelin larch (Larix gmelinii (Rupr.) Rupr.), which occupies about 57 % of the forest lands. The area of forests and th...
features of the Structure of Pine Stands on Bolshoy Solovetsky Island
The studies were carried out on Bolshoy Solovetsky Island in the White Sea. The research purpose is to identify the features of pine forests in the most frequent growing conditions on the island. For this purpose, 34 sam...
Hardening and Stabilization of Volumetric Properties in Aspen and Poplar Wood with Cardanol
Aspen and poplar are the least required types of wood in the Russian Federation, whose stock is continually expanding. Such wood can be used as a substitute for valuable hardwood, but in this case the strength must be al...
Quality Control of Activated Carbon by the Nuclear Magnetic Resonance Method
The production of activated carbon by pyrogenetic decomposition is a complex high-temperature process that involves several stages. The quality of the produced activated carbon primarily depends on the moisture content o...
Regulation of Sap Release when Tapping Betula pendula Roth
The study showed a correlation between the intensity of sap release by birch trees and the trunk diameter, degree of crown development, and tree age. In addition to the characteristics of trees, sap release intensity als...