A Rapid and Non-Destructive Technique in Determining The Ripeness of Oil Palm Fresh Fruit Bunch (FFB)
Journal Title: Jurnal Kejuruteraan - Year 2018, Vol 30, Issue 1
Abstract
Oil palm industry is one of the main industries in Malaysia that contributes to the country’s gross domestic product (GDP). In the oil palm industrial sector, methods of planting, detection and assessment are very important to produce high quality palm oil. Currently, the ripeness of oil palm fresh fruit bunch (FFB) is estimated using eyesight (most common), computer vision, hyperspectral imaging, light detection and ranging (LiDAR), near infrared (NIR) spectroscopy, and magnetic resonance imaging. The objective of this research is to introduce a rapid and non-destructive technique in determining and assessing the ripeness of oil palm fresh fruit bunch (FFB) by using a LiDAR scanning system. The LiDAR scanning system is used to scan three types of oil palm fruits at different level of ripeness which is under ripe, ripe, and over ripe. The reflectance intensity that bounces off the fruits are gathered and analysed to determine the different level or ripeness. Even though the intensity value is purely relative, it is proportional to the reflectance or absorption rate from the LiDAR sensor. A rapid method to determine the ripeness of palm fruits using a LiDAR sensor was proposed by calculating the reflectance percentage from 0% to 100% using the concept of linearity.
Authors and Affiliations
Zuhaira Mohd Zulkifli, Fazida Hanim Hashim, Thinal Raj, Aqilah Baseri Huddin
Keywords
Related Articles
- EP ID EP455537
- DOI 10.17576/jkukm-2018-30(1)-12
- Views 111
- Downloads 0
Sun Outage Calculator for Geostationary Orbit Satellites
Sun outages in satellite communication occur when the sun, a powerful broadband microwave noise source, passes directly behind the satellite (when viewed from Earth), causing the receiver with the beam directed towards t...
Preliminary Study of Alkaline Direct Ethanol Fuel Cell by Using Crosslinked Quaternized Poly (Vinyl Alcohol)/Graphene Oxide Membrane
A crosslinked of Quaternized Poly (vinyl alcohol)/Graphene oxide (QPVA/GO) composite membrane was prepared via quaternization and solution casting method. With the main objective is to performed lower ethanol permeabilit...
Heat Transfer Enhancement of Laminar Flow in a Circular Tube Using Swirl/Vortex Generator
Swirl/vortex fl ow generator is an important form of passive augmentation techniques consist of a variety of tube inserts, geometrically varied fl ow arrangements and duct geometry modifications that produce flows. Twist...
Behavioral Analysis of Thermoelectric Module under Different Configurations and Temperature Gradien
This study analyzes the behavior of the thermoelectric module (TEM) in a transient status which allows natural cooling condition. The analysis mainly aims to extract energy from the ordinary heat source and convert it in...
Vortex Measurement at Bell-Shaped Pump Inlet Using Particle Image Velocimetry
The vortex formed at the pump intake is known to be the main factor affecting the performance of a pump and it contributes directly to the increase of energy consumption. This study was aimed at obtaining an in-depth vis...