Agent Based QoS Routing using DSR in Mobile Ad hoc Network
Journal Title: International Journal for Research in Applied Science and Engineering Technology (IJRASET) - Year 2014, Vol 2, Issue 7
Abstract
This paper modifies the existing DSR routing protocol by using the neuro-fuzzy agent. The proposed system uses the neural as well as the fuzzy agents to improve the QOS of DSR routing protocol. Neural and fuzzy agents are used to select the optimal path on the basis of the attributes of the nodes. The proposed system firstly determines the preferred path from the multiple paths between the source and the destination by using the fuzzy rules. The fuzzy rules use the bandwidth, path cost, packet loss, energy consumed as the input parameter and the probability of selection as the output parameter. If the probability of all the nodes is same then the neural agents are used to get the final path. The neural uses the total cost of each as input to get the total cost of the resultant path
Authors and Affiliations
Monika Arora, Deepak Goyal
Keywords
Related Articles
- EP ID EP18458
- DOI -
- Views 300
- Downloads 12
slugAcoustic Echo Cancellation by Adaptive Combination of Normalized Sub band Adaptive Filters by Using Stochastic Gradient Algorithm
Acoustic echo is a common occurrence in today’s telecommunication systems. It occurs when an audio source and sink operate in full duplex mode; an example of this is a hands-free loudspeaker telephone. In this situation...
Understanding the Convolutional Neural Network & it’s Research Aspects in Deep Learning
Convolutional Neural Network (CNN) is the most important Deep Neural Network (DNN) architecture to implement the Deep Learning’s application of data and pattern representation in an effective and efficient manner. It us...
Designing of a Coaxial fed antenna for S-band Applications
A Microstrip patch antenna is designed for coaxial feeding technique for wireless microstrip patch antenna i.e S-Band applications. In this paper the antenna is resonating at 2.8 GHz frequency range which is desired fre...
Neuro-Fuzzy Modeling of Design Parameters of Connecting Rod
Finite element analysis is frequently used for the simulation of complex shaped mechanical systems, under the complicated loading conditions; however, it is usually time consuming and difficult for the parametric design...
Various Methods to reduce the Peak to Average Power Ratio in Orthogonal Frequency Division Multiplexing
The increasing demand on high bit rate and reliable wireless and wire line system has junction rectifier to several new rising modulation techniques. one among the techniques are going to be Orthogonal Frequency Divisio...