An Effect of Wall Corner Radius of Punch on the Features of the Hexagonal Cup Fabricated by the Deep Drawing Process
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2019, Vol 9, Issue 1
Abstract
This work aims to study the effect of different deep drawing process parameters on the distribution of strain and thickness in deep drawing operation, such as wall corner radius of punch, the thickness of the sheet, and drawing speed using experimental and finite element simulation. The deep drawing die was designed and constructed to carry out the experimental work required to produce a hexagonal cup with inner dimensions (41.5 mm by 36 mm), (28 mm) height drawn from a circular flat blank (80 mm diameter), made from low carbon steel (AISI 1008). The analysis program (ANSYS 18.0) to perform the finite element method to perform the analytical side of the search. Four types of wall corner radius of punch (R_c=1, 3, 5,7mm) with constant punch profile radius equal to (R_p = 6mm) and dieprofile radius equal to (R_d=6 mm) were used. From experimental work and simulation results, it has been found that, the maximum thinning take place at corner of the cup area with a wall corner radius of punch equal to (R_c= 1 mm) and maximum thickening take place at the at cup end with wall corner radius of punch equal to (R_c= 7 mm), the maximum values of strains (radial, hoop, thickness and effective) take place at end of cup with wall corner radius of punch equal to (R_c= 7 mm).
Authors and Affiliations
Adnan A. Ugla, Ali T. Ikal
Keywords
Related Articles
- EP ID EP463862
- DOI 10.24247/ijmperdfeb201923
- Views 75
- Downloads 0
Prospective Evaluation of Pumpkin Seed Oil as an Alternative Fuel - A Novel Experimentation
There is a major issue worldwide on the level of contamination caused by emissions of I. C. Engines that debilitate the issues concerning the high cost of raw petroleum. This has prompted an alternative for diesel engine...
Design and Testing of Rocket Motors with Composite Propellants
In space missions, satellite launchings and missiles for army applications, solid rocket motors plays a major role. As we know that the thrust produced by the rocket engines only gives the forward motion to the rocket bo...
Wear Behavior of Fe-Cr-V based Hard Facing Alloy on ASTM A105 Steel
Dynamic contact surfaces life rate depends on various factors, majorly it is influenced by wear between contact surfaces. Hard facing is one of ancient technique used to improve mechanical properties, majorly surface pro...
On the Application of Particle Swarm Optimization in Minimum Time Launch Vehicle Trajectory Optimization Problem
The application of Particle Swarm Optimization (PSO), in solving minimum time trajectory optimization problem, studied in this paper. The ascent phase of a launch vehicle trajectory is considered, due to its highly nonli...
Effect of Polyacrylamide with ZnO Nano Aqueous Solution on the Chemical Flooding Method with Enhanced Oil Recovery EOR) – An Experimental and Modelling Study
This work studied the effect of polyacrylamide (PAM) with ZnO nanoparticles (NPs) solution on the recovery of crude oil in tertiary stage. Shear viscosity due to shear rate and salt concentration, also shear stress with...