ANALYSIS OF THE STRUCTURE AND TRIBOLOGICAL PROPERTIES OF SINTERED STAINLESS STEELS
Journal Title: Tribologia - Year 2017, Vol 272, Issue 2
Abstract
Increasing development of civilization encourages the search for modern engineering materials. At present, very interesting and promising materials are sintered stainless steels that are considered to be the most rapidly developing group of materials, which is related to the demand for materials with good mechanical properties and high resistance to corrosive agents. Taking into account sintered austenitic–ferritic steels, it is possible to obtain a structure with different proportions of the two basic structural components. The main problem limiting the applicability of sintered stainless steels is porosity, which deteriorates not only the strength properties but also the usability as compared to their cast and materials after plastic working. Extremely valuable factors influencing tribological properties are the chemical composition, proportion of individual powders and sintering conditions. In this study, the microstructure and tribological properties of sintered stainless steels obtained by sintering in different proportions of 316L austenitic steel and 409L ferritic steel were compared. The abrasion wear resistance test for individual sintered steels was performed by pin-on-disc method.<br/><br/>
Authors and Affiliations
Barbara LISIECKA, Agata DUDEK, Katarzyna STRZELCZAK
Keywords
Related Articles
- EP ID EP240857
- DOI 10.5604/01.3001.0010.6312
- Views 84
- Downloads 0
THE INFLUENCE OF ADDED WATER ON FUEL INJECTOR WEAR IN A DIESEL ENGINE
The article presents the problem of the wear of the components of injection apparatus of a self-ignition engine during the addition of water. The observer was subject to an injector from the KIPOR KDE3500E generator set...
ANALYSIS OF THE VALUES OF HYDRODYNAMIC PRESSURE AND LOAD CARRYING CAPACITIES FOR VARIOUS METHODS OF SOLVING A REYNOLDS TYPE EQUATION
Calculations of the hydrodynamic pressure distribution in the slide bearing gap occur most often on the basis of ready-made computer programs based on CFD methods or one’s own calculation procedures based on various nume...
RESISTANCE TO WEAR AS A FUNCTION OF THE MICROSTRUCTURE AND SELECTED MECHANICAL PROPERTIES OF MICROALLOYED STEEL WITH BORON
The paper presents the structure and the results of abrasive wear resistance tests of XAR®600, TBL PLUS, and B27 steel. As a result of the tests conducted by means of light and scanning microscopy, it has been proven tha...
TARCIE STATYCZNE W ODWRÓCONYCH PARACH ŚLIZGOWYCH METAL–ELASTOMER
Współpraca ślizgowa materiałów o różnych twardościach (odkształcalności), np. materiał polimerowy współpracujący z materiałem metalicznym, występuje w elementach maszyn w jednym z dwóch następujących wariantów: para pros...
WEAR RESISTANCE OF CONSTRUCTIONAL MATERIALS IN COOPERATION WITH THE OXIDE COATING
This article presents the results of tribological tests, stereometric tests, and surface morphology tests carried out with steel structural materials prepared according to ANSI: 304, 316, 52100 and ceramic structural mat...