APPLICATIONS OF FULL FACTORIAL DESIGN EXPERIMENTS FOR LASER WELDING
Journal Title: TEHNOMUS - Year 2011, Vol 18, Issue 1
Abstract
Laser welding using Nd: YAG laser with continuous emission is applied for a low alloyed steel. The study pursued molten areas characteristics in the material. On the weld cross section was measured weld width, weld depth and the weld molten zone. Their variation was analyzed with power and welding speed. A full factorial experimental design was applied for two particular values of the distance between focal plane and the workpiece surface (defocusing depth). It presents mathematical models, the ranking effects by Pareto charts, response surface method and the multiple ANOVA analysis of variance. It showed the main effect of laser power in determining the weld characteristics.
Authors and Affiliations
Remus Boboescu
Keywords
Related Articles
- EP ID EP134660
- DOI -
- Views 132
- Downloads 0
RESEARCH ON HOLLOW CATHODE EFFECT AND EDGE EFFECT AVOIDANCE IN PLASMA NITRIDING TREATMENT
This paper contains a description of the nitriding installation with unpolarized grid in order to avoid hollow cathode effect and edge effect. For the experimental study we have made wedge samples cut, and triangular pri...
EXPERIMENTAL RESEARCH ABOUT INFLUENCE OF INCLINATION ANGLE DIRECTION UPON THE SURFACE ROUGHNESS IN BALL END MILLING OF OLC45 (C45) MATERIAL
Machining with ball end mills become a very usefull process to obtain pieces with complex surfaces. Possibilities of machining with ball nose end mills represent a adequate process to achieve surfaces with a good quality...
RESEARCH ON STRESS AND DEFORMATION STATE IN PLASTICAL BENDING WITH STRETCHING
The paper presents a theoretical solution of the stress and deformation state in plastically bending with stretching. It was established calculus relations of the neutral layer relative displacement coefficient, bending...
OPTIMIZATION OF THE PLASTIC INJECTION PROCESS THROUGH THE MODIFICATION OF THE PROCESS FUNCTIONAL PARAMETERS
The paper presents the optimization of the plastic injection process through the reduction of the cooling and removing times. For the deployment of the experiment the PA 6 polyamide will be used. The SolidWorks and Moldf...
THE INFLUENCE OF TEMPERATURE ON SULFUR AND NITROGEN OXIDES IN THE ATMOSPHERE OF BOTOSANI MUNICIPALITY
The pollutants life cycle implies emission, dispersion, transport, chemical transformation and their submission to the earth surface. Spreading of impurities issued and their transformation in immission depends on the we...