Aspects of Nitrated Layer Structure for Some Types of Austenite Stainless Steel
Journal Title: Analele Universitatii "Dunarea de Jos" din Galati. Fascicula IX, Metalurgie si Stiinta Materialelor - Year 2006, Vol 29, Issue 1
Abstract
The analysis of nitrated layer diffractograms and the structure marked out the presence of complex nitrides combinations layer for all types of steel except for code 6 steel type 2CuMoNiCr200 which because of the very high index of austenite stability, 29.9, presented a layer made of nitrogen solid connate solution in austenite. In the case of stainless austenite steel types nitrogen diffusion and, consequently nitrated layer formation depends on the concentration of alloying elements in steel, on austenite stability indices. Code 2 and code 3 steel types that have the smallest stability indices have the thickest layer and are followed by code 3 and code 4 steel types. On the fifth place is code 1 steel type which has a thinner layer, approx. 21 jam and on the last place there is code 6 steel type that, as it was shown, does not form a nitrides layer.
Authors and Affiliations
Ovidiu Dima, Sanda LEVCOVICI, Constantin GHEORGHIEČ
Keywords
Related Articles
- EP ID EP663907
- DOI -
- Views 65
- Downloads 0
Influence of Sintering Temperature on the Structure of the Yttrium Based Phosphor Nanoparticles
Yttrium-based phosphor materials belonging to the class known as garnets have witnessed a strong return with the development of the first white LEDs. Among these materials, yttrium aluminum garnet doped with cerium has b...
Microstructural Characteristics of Sintered Powder Metallurgy Alloys
The purpose of this paper is to study the influence of processing parameters on the microstructural characteristics of sintered powder metallurgy alloys. The specimens were produced from atomised iron powders with differ...
Modifying the Structure and Surface Properties of Ti6Al4V Alloy by Carbonitriding in Fluidized Bed
The Ti6Al4V alloy is known as being one of the most widely used biocompatible alloys and not only that. The study is based on experienced research of the hardening in a fluidized bed and applied to samples of Ti6A14 in l...
Analysis of Titanium Interface and Tungsten Exterior Layer Thickness Coated by Vibrator Electrode Method
The goal of this paper is to create metallic materials with superior functional performances. The layer obtained by electrode vibrator method must have a very good adherence on part surface and a high chemical and therma...
Low Potential Heat Recovery Using Heat Pumps
This paper presents a study on the possibility of recovering low thermal potential heat from the cooling technological water of industrial processes. The analysed solution consists in the use of a heat pump which would s...