Cytogenetic Characteristics of Seed Progeny of Scots Pine Plus Tree Clones in Karelia
Journal Title: Lesnoy Zhurnal (Russian Forestry Journal) - Year 2022, Vol 13, Issue 1
Abstract
The article describes the cytogenetic parameters of seed progeny of Pinus sylvestris plus trees growing in the Petrozavodsk seed orchard of the first order. P. sylvestris normal trees from the natural pine phytocenosis in the Pryazha region (Karelia) were taken as a control. The following indicators were considered: relative DNA content, number of chromosomes, frequency and types of mitosis pathologies at the metaphase, anaphase and telophase stages (in % of the total number of dividing cells at the same stages). It was found that the root meristem of the P. sylvestris seed progeny contains 24 chromosomes in the diploid set. Single aneuploid cells (2n = 23; 2n = 25) were found in the studied plants. The most frequent is monosomy (2n = 23). It made up 81 % of the total number of aneuploid cells. The relative DNA content in the young needles of pine seedlings of plus clones and normal trees was 42.07±0.21 and 42.95±0.04 pg, respectively, and the difference between the two was statistically significant (U-test, p ˂ 0.01). Cytogenetic analysis revealed 7 types of mitosis pathologies: chromosome fragmentation, chromosome bridges, chromosome overlap, isolation of chromosomes and groups of chromosomes, chromosome lagging, multipolar mitosis and complex abnormalities. Chromosome overlap was the most common pathology in the general mitotic disorders spectrum. Comparison of mitosis pathologies in two general samples of normal trees and plus tree clones showed that they significantly differ by the following mitosis abnormalities: overlap and isolation of chromosomes in metaphase, fragmentation, lagging, bridges and multipolar mitosis in the anaphase and telophase. The study shows that the proportion of cells with mitosis abnormalities in the seed progeny of normal trees was about 1.5 times higher than of plus tree clones, and is equal 3.44±0.32 and 2.38±0.14 % (U-test, p = 0.05), respectively. The data obtained demonstrate the cytogenetic stability of the seed progeny of P. sylvestris clones from the Petrozavodsk seed orchard of the first order, which in turn may indicate the high quality of the seed material. For citation: Ignatenko R.V., Ershova M.A., Galibina N.A., Raevsky B.V. Cytogenetic Characteristics of Seed Progeny of Scots Pine Plus Tree Clones in Karelia. Lesnoy Zhurnal [Russian Forestry Journal], 2022, no. 1, pp. 9–22. DOI: 10.37482/0536-1036-2022-1-9-22
Authors and Affiliations
Roman V. Ignatenko, Maria A. Ershova, Nataliya A. Galibina, Boris V. Raevsky
Keywords
Related Articles
- EP ID EP700457
- DOI 10.37482/0536-1036-2022-1-9-22
- Views 96
- Downloads 0
Morphological Variability of the Assimilation Apparatus of Pinus sylvestris L. within the Teberda National Biosphere Reserve
Pine forests are widespread in the Karachay-Cherkess Republic, in particular, in the Teberdinsky National Biosphere Reserve, mainly in its northern part. The variability 0 of pine morphological parameters is associated w...
Range Expansion of Cotoneaster lucidus Schlecht. in Forest Parks of Yekaterinburg
Shiny cotoneaster (Cotoneaster lucidus Schlecht.) is one of the oldest plants. It originated in Southeast Asia and has many primitive traits. Its survival strategy is fascinating. Its introduction range extends throughou...
Features of Changing Structural and Morphological Properties of Bamboo Pulp During Refining
The wood of tropical plants, including bamboo, has great potential due to its rapid growth, simple cultivation, low cost, and characteristics suitable for the pulp and paper industry. The study considers the structural-m...
Experimental Evaluation of Strength of End Joints with Rectangular Pressed Fingers
End jointing of wooden blanks is widely distributed in the manufacture of wood products. The most commonly used splicing technology on finger joints with pointy fingers has a number of drawbacks, including the presence o...
Stiffness Analysis of Connections of LVL Structures with Claw Washers
The use of claw washers in dowel connections allows to increase the bearing capacity and stiffness of joints. However, joint action of claw washers and dowels in the structures of advanced materials is studied insufficie...