Deformation zone size around drilled hole in DP steels
Journal Title: Materials Engineering - Materialove inzinierstvo (MEMI) - Year 2014, Vol 21, Issue 2
Abstract
In the present study, there are given results of the experimental tests primarily focused on determination of dimension of plastic strained layer near drilled hole surface. Three hot rolled low carbon steels with strength ranging 416 to 967 MPa (conventional mild steel and two micro alloyed steels) were examined in the state after annealing to eliminate residual stress and after intercritical quenching. It was found that the size of deformation zones (determined by differential interference contrast light microscopy) as well as thickness of hardened layer (determined by micro-hardness tests) can be correlated with the macro-hardness of steels, however, they are also dependent on their microstructure.
Authors and Affiliations
Gejza Rosemberg, Iveta Sinaiova, Lubos Juhar
Keywords
Related Articles
- EP ID EP158465
- DOI -
- Views 102
- Downloads 0
STRUCTURAL CHARACTERISTICS & DIELECTRIC PROPERTIES OF TANTALUM OXIDE DOPED BARIUM TITANATE BASED MATERIALS
In this research, the causal relationship between the dielectric properties and the structural characteristics of 0.5 & 1.0 mole % Ta2O5 doped BaTiO[sub]3[/sub] based ceramic materials were investigated under differe...
SHOT PEENING INFLUENCE ON CORROSION RESISTANCE OF AE21 MAGNESIUM ALLOY
Evaluation of the electrochemical characteristics of the AE21 magnesium alloy is presented in the article. The surfaces of tested alloys were treated by grinding and grinding followed by sodium bicarbonate shot-peening....
Influence of process parameters on torsional strength, impact toughness and hardness of dissimilar AISI 304 and AISI 1021 friction welded steels
In this present study an attempt was made to join austenitic stainless steel (AISI 304) with low alloy steel (AISI 1021) at different rotational speeds and at different axial pressures and then determining the strength o...
THE ANALYSIS OF CAUSES OF LORRY PISTON COMBUSTION ENGINE DAMAGE
The article deals with analysis of causes of lorry piston combustion engine damage. For docummentation and analysis of causes was used macroscopical, microscopical and scanning electron microscopy. The analysis showed th...
IMPACT STRENGTH AND FAILURE ANALYSIS OF WELDED DAMASCUS STEEL
The aim of this work was the experimental research of damascus steel from point of view of the structural analyze, impact strength and failure analyzes. The damascus steel was produced by method of forged welding from ST...