Design of a car body part using reverse engineering and FEM
Journal Title: Proceedings in Manufacturing Systems - Year 2018, Vol 13, Issue 3
Abstract
Deep drawing, as the main technology for obtaining car body parts, is one of the fields where the virtual design of parts and process is used for product development. The use of FEM in sheet metal forming processes is an efficient tool of virtual design that has replaced the physical try-out method in terms of costs and time consuming. In the paper steps necessary in virtual design and verification of a car body part are presented. The design process starts with the design analysis and the creation of the part model using reverse engineering. Then the model is analyzed using FEM. By numerical simulation is obtained the form and the dimensions of the blank. After defining the deep drawing tool the process of deformation is modeled. An analysis of part, in terms of geometry, thickness and stresses variation is made. It is presented the module of forming limit diagram of the program and the results of the analysis of the part using this module. Finally, the results of this study could be used and improved by the car manufacturers.
Authors and Affiliations
Viorel PAUNOIU, Virgil Teodor, Melania Tera, Nadia BELU, Ciprian CIOFU, Nicolae TAMPU
Keywords
Related Articles
- EP ID EP415377
- DOI -
- Views 124
- Downloads 0
Control system and software package for an experimental module for robots applied in laparoscopyc surgery
The main target of everyone engineering work associated with minimally-invasive surgery is to provide adequate tool-tissue force information to the surgeons so that they can regain the "sense of touch" that has been lost...
Review of the present technological advance in the field of water jet cutting
Water jet cutting (WJC) is a relative recent technology that has a high interest due to its results. The main advantage in using this flexible non-conventional technology is that there is no heat-affected zone (HAZ). Ano...
TRANSITION FROM THE CLASSIC SERVICE OPERATIONS TO THE DECISION SUPPORT IN MAINTENANCE ACTIVITY
This paper introduces the researches performed for highlighting the development from classic service operations to decision support in maintenance activity. The use of the monitoring software of Schindler Company – manuf...
Surface roughness monitoring in cutting force control system
The aim of this contribution is to present a reliable cutting force control system in end milling with the main focus on the integrated surface roughness prediction model. In this control system, cutting force sensor is...
THE ENTERPRISE IPSEC VPN SOLUTIONS
Now, in the 21st century, all enterprise have a local area network, a virtual private network, an Intranet and Internet, servers and workstations for operations, administration and management working together for the s...