Design of Data Acquisition System for a Base Transceiver System Room Using ARM Processor
Journal Title: International Journal of Electronics Communication and Computer Technology - Year 2014, Vol 4, Issue 3
Abstract
The main aim of this work is to design a system for reducing the wastage of electricity in BTS room and also to handle the scarcity of electricity which causing serious dislocation in all spheres of life. Here we are using a free cooling unit which Provides a ventilation system and its main objective is to reduce motor run time and save electricity cost at the BTS sites. The controllers also maintain the room temperature under a predetermined value by controlling the Fan Unit. If the BTS room temperature is not under a tolerant level then the Processor gives command to Fan unit to ON. The temperature values are displayed in LCD. If the values exceed beyond the threshold limit this information is messaged to user using GSM module. One of the major operations of this work is to store the room temperature and outdoor temperature data in to a permanent memory EEPROM.
Authors and Affiliations
Arun Alla| DECS, Department of ECE, G. Pullaiah College of Engineering and Technology, Kurnool, Andhra Pradesh, India, Dr. P. Nageswara Rao| Professor, Department of ECE, G. Pullaiah College of Engineering and Technology, Kurnool, Andhra Pradesh, India
Keywords
Related Articles
- EP ID EP8405
- DOI -
- Views 396
- Downloads 17
Comparative Study of 4G Technology, Applications and Compatibility in Prevailing Networks
With increasing end user demands for wider service due to the rapid growth and variety of IT (information technology) industry, the service with the data rate of 30 Mbps cannot accommodate the future mobile multimedia en...
Text to Speech Conversion with Phonematic Concatenation
This paper presents a method to design a Text to Speech conversion module by the use of Matlab by simple matrix operations. Firstly by the use of microphone some similar sounding words are recorded using a record program...
Stagnant Timing investigation of Embedded Software on Advanced Processor Architectures
Most processors today are embedded in products like mobile phones, microwave owns, welding machines etc and are not used in PC’s as many believe Since some of these embedded computers are used in time-critical or safety-...
Design and Verification of Serial Peripheral Interface using OVM
The main objective of the work is to design SPI Master Core using Verilog and verify the code using Open Verification Methodology. Serial Peripheral Interface (SPI) is an interface that facilitates the transfer of synchr...
Low Power Single Phase Clock Multiband Flexible Divider Using Low Power Techniques
In this paper, a low-power single-phase clock multiband flexible divider for Bluetooth, Zigbee, and IEEE 802.15.4 and 802.11 a/b/g WLAN frequency synthesizers is proposed based on pulse-swallow topology and is implem...