Design of Multi-Layer Optical Fibers with Ring Refractive Index to Reduce Dispersion and Increase Bandwidth in Broadband Optical Networks
Journal Title: Engineering, Technology & Applied Science Research - Year 2012, Vol 2, Issue 3
Abstract
The main goal in this paper is to design single-mode optical fibers for DWDM networks, which are used today in rapid communications. These networks require low dispersion in a wide range of wavelengths. So, in this paper, multi-layer optical fibers with low dispersion value and flat dispersion slope in wavelength range of 1.5-1.6µm) are designed, using optimization algorithms.
Authors and Affiliations
M. Seifouri, M. M. Karkhanehchi, S. Rohani
Keywords
Related Articles
- EP ID EP88629
- DOI -
- Views 292
- Downloads 0
Mitigating the Adverse Impact of Un-Deterministic Distributed Generation on a Distribution System Considering Voltage Profile
Electric power systems are enforced to operate near to their stability limit due to the fast increase in power demand. Therefore, voltage stability has become a primary concern. The main cause of voltage variations is th...
An Investigation of Temperature and Wind Impact on ACSR Transmission Line Sag and Tension
Power transmission is mainly based on overhead transmission lines with conductors being supported by transmission towers. Transmission lines are subjected to environmental stress (temperature changes, winds, snow etc), h...
Cumulative Effect of Crumb Rubber and Steel Fiber on the Flexural Toughness of Concrete
Concrete properties, such as toughness and ductility, are enhanced to resist different impacts or blast loads. Rubberized concrete, which could be considered a green material, is produced from recycled waste tires grinde...
Using Ecotech Architecture as an Effective Tool for Sustainability in Construction Industry
Ecotech architecture can be used as an effective strategy to minimize energy consumption and enhance the satisfaction of construction industry beneficiaries in the Middle East. The use of ecotech principles has been empl...
Influence of Field Spacer Geometry on the Performance of a High Voltage Coaxial Type Transmission Line with Solid Dielectric Spacer in Vacuum
With the development of more powerful high power electromagnetic sources, the transmission of high voltage power particularly between pulsed power systems to huge power rated microwave sources in absence of electrical br...