Destruction zone near the tip of interfacial crack at a prevailing tensile loading
Journal Title: Вісник Тернопільського національного технічного університету - Year 2016, Vol 81, Issue 1
Abstract
Under the plane strain conditions at the prevailing tensile loading by Wiener-Hopf method the solutions of problems about the calculation of a small-scale destruction zone in the pre-fracture zone part, which is adjacent to the interface crack tip, located on a flat interface of two different materials, taking into account and ignoring the contact of the lips near the tip have been found. The influence of the elastic characteristics of joining materials and loading configurations on the parameters of the destruction zone has been investigated.
Authors and Affiliations
Mykhailo Volodymyrovych Dudyk
Keywords
Related Articles
- EP ID EP249152
- DOI -
- Views 67
- Downloads 0
Investigation of transportation bulk cargo sloping screw conveyor
Screw conveyers, which are characterized by the simple design, high reliability, easy handling and adaptation in the automated systems being ecologically-friendly, have been widely used for the technological operations o...
Hollow block floor’s survey of the building of the early 20th century using modern diagnostic methods
The article provides the results of technical survey of the building of the beginning of the 20th century using modern non-destructive testing devices. The possible variants of the design of monolithic hollow floors are...
Phototherapy device with determination of absorbed energy dose
The article deals with comprehensive analysis of the most common design of devices being used for human skin irradiation in phototherapy. The authors determined that their main drawback is the lack of the possibility of...
Investigation of characteristic of powder wire with the CUO/Al exothermic mixture
The paper the results of research is presented and the level of influence of the parameters of surfacing and the amount of exothermic mixture in the composition of self-shielding flux-cored wire on the deposition rate fa...
Quality of turning using multiedge heads with elastic guiedes and elctromagnetic drives
The paper deals with experimental facilities including adaptive type multi edge head with elastic guides for fine turning. The adjustment of the head cutting edges positions in the process of machining is performed by tw...