Diagnosis of edge condition based on force measurement during milling of composites
Journal Title: Archives of Mechanical Technology and Materials - Year 2018, Vol 38, Issue
Abstract
The present paper presents comparative results of the forecasting of a cutting tool wear with the application of different methods of diagnostic deduction based on the measurement of cutting force components. The research was carried out during the milling of the Duralcan F3S.10S aluminum-ceramic composite. Prediction of the tool wear was based on one variable, two variables regression, Multilayer Perceptron (MLP) and Radial Basis Function (RBF) neural networks. Forecasting the condition of the cutting tool on the basis of cutting forces has yielded very satisfactory results.
Authors and Affiliations
Paweł Twardowski, Agata Falusiak
Keywords
Related Articles
- EP ID EP535820
- DOI 10.2478/amtm-2018-0002
- Views 77
- Downloads 0
The numerical investigation of thin-walled beams with modified C-sections
Demand for thin-walled structures has been increasing for many years. Cold-formed, thin-walled channel beams are the subject of presented research. The local elastic buckling and limit load of these beams subjected to pu...
Stabilisation problem in biaxial platform
The article describes investigation of rolling ball stabilization problem on a biaxial platform. The aim of the control system proposed here is to stabilize ball moving on a plane in equilibrium point. The authors propos...
Comparison of selected surface topography parameters after the turning of Inconel 625 obtained by the additive techniques to the parameters of the material made by the traditional techniques
The paper presents the possibilities of additive manufacturing of the selected alloy, Inconel, for production of ready-made elements. The results of surface topography examination of the material manufactured with the us...
Design of The Test Stand for Hydraulic Active Heave Compensation System
The article presented here described the design of a test stand for hydraulic active heave compensation system. The simulation of sea waves is realized by the use of hydraulic cylinder. A hydraulic motor is used for sea...
The influence of laser re-melting on microstructure and hardness of gas-nitrided steel
In this paper, modification of nitrided layer by laser re-melting was presented. The nitriding process has many advantageous properties. Controlled gas nitriding was carried out on 42CrMo4 steel. As a consequence of this...