Direct Spectrophotometric Determination of Glimepiride in Pure Form And Pharmaceutical Formulations Using Bromocresol Purple
Journal Title: JOURNAL OF ADVANCES IN CHEMISTRY - Year 2018, Vol 15, Issue 2
Abstract
A simple, direct and accurate spectrophotometric method has been developed for the determination of Glimepiride (GLM) in pure and pharmaceutical formulations by complex formation with bromocresol purple (BCP). The method involves the formation of a yellow ion-pair complex between BCP with glimepiride at pH<3,8; after reacting GLM with Na2CO3 to give C24H33N4H+O5NaS which is extracted by chloroform. The formed complex [GLM]:[ BCP] was measured at lmax 418 nm against the reagent blank prepared in the same manner. Variables were studied in order to optimize the reaction conditions. Molar absorptivity (e) for complex was 20600 L.mol-1.cm-1. Beer’s law was obeyed in the concentration range of 1.226 – 46.608 mg.mL-1 in present of 5.0x10-4 mol/l of BCP with good correlation coefficient (R2= 0.9997). The relative standard deviation did not exceed 3.6%. The limit of detection (LOD) and the limit of quantification (LOQ) were 0.15 and 0.46 mg.mL-1, respectively. The proposed method was validated for specificity, linearity, precision and accuracy, repeatability, sensitivity (LOD and LOQ) and robustness. The developed method is applicable for the determination of GLM in pure and different dosage forms with average assay of 98.8 to 102.0% and the results are in good agreement with those obtained by the RP-HPLC reference method.
Authors and Affiliations
Abdul Aziz Ramadan, Souad Zeino
Keywords
Related Articles
- EP ID EP653152
- DOI 10.24297/jac.v15i2.7454
- Views 180
- Downloads 0
Method development and validation of simultaneous determination of seventeen metals in water by ICP/MS
A simple, precise, accurate, and sensitive method is developed and validated for simultaneous determination of seventeen metals (Li, Sr, Ba, Tl, Pb, Bi, Al, K, Cr, Mn, Co, Ni, Cu, Zn, Mo, Ag, and Cd) in water by ICP-MS....
Performance of Al-si-glass fiber composite piston in an IC Engine
The piston is one of the major part of the automobile. The piston purpose is to transfer force from expanding gas in the cylinder to the crankshaft. The piston acts as the vital link between the generation of power insid...
ASURVEY ON CLUSTER BASED LOAD BALANCINGAPPROACHESFOR WIRELESSSENSOR NETWORK
Wireless sensor network (WSN) is becoming a very interesting field of research in recent days. It has wide area of research due to various issues caused by the hardware capabilities of sensing nodes such as memory, power...
Study on sea sand as a partial replacement for fine aggregate
Sand researches around the world are in continuous search for the alternatives of sand. Fine aggregate is an important constituent of concrete and is required in large quantities. Generally, river sand is used as fine ag...
IMPROVING THE PERFORMANCES OF ELECTRO-DISCHARGE DRILLING PROCESS PARAMETERS
The variation in a machining process is reduced by Taguchi method through robust design of experiments. The primary objective of this method is to produce the parts with high quality at lower cost. Taguchi method is comm...