DIRECT THRUST CONTROL SCHEME FOR A TUBULAR LINEAR BRUSHLESS PERMANENT-MAGNET ACTUATOR
Journal Title: ANALELE UNIVERSITATII DIN CRAIOVA - Seria Inginerie electrica - Year 2010, Vol 34, Issue 34
Abstract
This paper investigates a suitable control scheme for tubular linear brushless permanent-magnet actuator (TLBLPMA) with the aim of revealing its efficiency in terms of fast and accurate dynamic response. Direct thrust control is proposed for a twophase TLBLPMA prototype, with its peculiarities in terms of dynamic performance. Simulation results for the direct thrust-controlled TLBLPMA drive system are presented.
Authors and Affiliations
Ioana-Cornelia VESE, Mircea RĂDULESCU
Keywords
Related Articles
- EP ID EP97159
- DOI -
- Views 137
- Downloads 0
MICRO-HYDROPOWER STATION FOR KINETIC ENERGY CONVERSION OF FLOWING WHATER
An efficient conversion of kinetic energy of river water into mechanical or electrical energy without building barrages is provided by micro-hydropower stations. Increased efficiency is achieved by an optimum position of...
Modeling and Torque Ripple Control in Faulty SPMSM
This paper presents a model of a Surface Permanent Magnet Synchronous Motor which can be used in a faulty case and a torque ripple control approach developed to be applied if the faulty case is detected. Two faulty cases...
Hardware Experiments for Simultaneous Control of Several Motors by a Microcontroller and a VHL Programming Language
The paper presents a hardware solution for the digital control of a multi-motor drive system using a very high level programming language and a single microcontroller. It follows a previous one for developing the softwar...
Small Scale Model of Automatic Barrier Powered by Photovoltaic Panel
Access control systems offer numerous benefits and are able to constitute extremely good solutions for securing an area of high or very high importance. An access control system allows restriction, monitoring and directi...
ETHERNET INTERFACE FOR A SYSTEM OF AUTOMATION WITH MICROCONTROLLER
Because the Internet is becoming more widespread, there was the possibility of communication with automation systems for configuration, reprogramming or control in real time. For this, the automation system needs a physi...