Effect of delayed insertion of composite resin on the bond strength of self-etching adhesive systems
Journal Title: RSBO - Year 2009, Vol 6, Issue 3
Abstract
Introduction: Technological advances in adhesive systems have resulted in materials with simplified techniques, which require less clinical steps.Objective: To determine the influence of immediate or delayed insertion of restorative material on the values of bond strength self-etching adhesives by using the micro tensile test. Material and methods: Bovine incisors were used, which had its vestibular surface abraded to obtain a flat dentin surface.Self-etching adhesive systems were used:Clearfil SE Bond (CSEB), Clearfil Tri S Bond (CTSB), AdheSE (ADS) and AdheSE One (ADO). The composite resin Z350 was adhered to this substrate at two different times: immediately and later (after 24 hours). Procedures were performed with simulated physiological pulpal pressure.Results were submitted to statistical analysis through Anova and Tukey’s test.Results: Except ADS, all materials tested showed reduction of the values of bond strength when composite resin was applied delayed, and only for single-step systems (CTSB and ADO) this reduction was statistically significant.Conclusion: Special care shall be taken when using single-step self-etching adhesive systems. It is recommended the application of an additional layer of hydrophobic material in order to reduce permeation of adhesive layer, and the insertion of composite resin should be initiated immediately after the photopolymerization of adhesive system.
Authors and Affiliations
Edson CAMPOS, José SAAD, Osmir OLIVEIRA JÚNIOR, Sizenando PORTO NETO, Lucas CAMPOS, Marcelo ANDRADE
Keywords
Related Articles
- EP ID EP139488
- DOI -
- Views 174
- Downloads 0
Evaluation of active chlorine releasing of sodium hypochlorite during seven days, stored at different temperatures
Introduction: The sanitation of the canal system through irrigation/aspiration, at the changing of the endodontic instruments aims to the excised material, removal of microorganisms and the cleaning of the walls of...
Evaluation of pH, solubility and marginal leakage in retrobturation cases using Sealer 26® alone or with iodoform
Introduction:Sealer 26® cement contains bisphenol epoxy resin associated with calcium hydroxide, presenting smaller radiopacity than other endodontic cements. Aiming to improve this property, iodoform has been added in i...
Ability of different methods to fill retrograde cavities with MTA
Introduction: The Mineral Trioxide Aggregate (MTA) has excellent biological property. However, its consistency makes it difficult to be inserted into retrograde cavities. Objective: To evaluate the ability of diffe...
Evaluation of dentin cleansing by a detergent derived from castor oil (Ricinus communis) used as root canal irrigant: a scanning electron miscroscopy study
Introduction and objective: To evaluate, by scanning electron microscopy (SEM), the cleaning of root canal walls after biomechanical preparation and irrigation with castor oil (Endoquil®) and 0.5% sodium hypochlorite (N...
Determination of pH, buffering capacity, total carbohydrates and sucrose in sugar-free and light processed fruit juices
Introduction: Tooth erosion is the irreversible loss of dental hard tissues caused by acids and/or chelation without bacterial involvement. Many studies showed that there is an increase of tooth erosion in population an...