Evaluating the Performance and Emission Characteristics of CI Engine with Waste Plastic Oil
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2019, Vol 9, Issue 3
Abstract
The continuous increase of demand for energy, diminution of oil recourses and stringent pollution norms encourage the researchers to find alternate fuels. Waste converted to fuel, a technique to get alternate fuels is an upcoming research. Waste plastic converted to liquid fuel is another alternate energy source path, which can contribute to depletion of fossil fuels and to help avoiding landfills. Performance and emission characteristics of a diesel engine fuelled with waste plastic oil were investigated. Diesel was replaced by various percentages of 10, 20, and 30% by volume with waste plastic oil. From the obtained results, observed the improvement in brake thermal efficiency (Bthe) and reduction in HC and CO emissions for waste plastic oil. Waste plastic oil 30 (W30) showed 11% higher Bthe than the pure diesel operation.
Authors and Affiliations
Radha Krishna Gopidesi, Goli Ravi Sankar, Appana Durga Pavan Kumar, Alladi Sukhesh Kumar, Bondalapati Srimal
Keywords
Related Articles
- EP ID EP617006
- DOI 10.24247/ijmperdjun2019109
- Views 102
- Downloads 0
Accident Prevention Eye Tiredness Detection Using Image Mining
Driver exhaustion is the majority frequent reason for the deadly highway accident around the earth. This shows that in the motor vehicle industry, particularly, anywhere a driver of a serious motor vehicle is frequently...
ROOMBOTS—MODULAR ROBOTS FOR ADAPTIVE FURNITURE
Autonomous mobile robot navigation has generated a lot of interest among researchers in recent years. Herein, we outline the design of a four-tracked autonomous mobile robot with a main-controller regulated on the basis...
Effect of Cooled EGR Technique on Performance and Emissions of CRDI Engine Operated with Biodiesel Blends
Hazardous pollutants and limited sources of fossil fuels made power dependent sectors to focus on alternative sources. However, complete replacement is still constrained and challenging. Attempts to assure complete repla...
Motion Control of Electro-Pneumatic System based on Directional Control Solenoid Valve
This work is concerned with the design and implementation of position control electro-pneumatic system using ON/OFF solenoid directional control valves. To realize this approach, it's required to set up a laboratory mech...
SINTERING OF IRON POWDER MIXTURES AND DETERMINING THEIR MECHANICAL PROPERTIES
In this investigation, iron-based powder-metal compacts with two distinctive mesh sizes were sintered utilizing microwave heating framework. Iron-based powders of 100 mesh and 300 mesh were blended with mass portions w =...