Evaluation of direct reading photoionization detector performance under various operational parameters
Journal Title: Environmental Health Engineering and Management Journal - Year 2021, Vol 8, Issue 2
Abstract
Background: A hand-held portable direct-reading monitor, including photoionization detector (PID) is renowned for its good sensitivity, considerable dynamic range, and nondestructive vapor detection ability in comparison to the tardy response of the PID in gas chromatography (GC), which its application has been restricted. In this study, the performance of a PID system (MultiRAE Lite) was evaluated as a replacement of GC in the measurement of toluene in a dynamic adsorption system. Methods: The test was done at different relative humidity levels (30%, 50%, and 80%), temperatures (21, 30, 40°C), and toluene concentrations (20, 100, 200, and 400 ppm). Results: The PID achieved 48% of all measurements meeting the comparison criterion. The results showed that the performance of the PID could be altered by the variables. The best performance of the PID was at temperature of 21°C, the relative humidity of 50%, and concentration of 200 ppm with the percentage of readings achieving the criterion of comparison to 58%, 54%, and 52%, respectively. The averages of the PID readings (mean ± SD at 200 ppm= 207.9 ± 8.7) were higher than the reference method measurements averages (mean ± SD at 200 ppm= 203.5 ± 5.8). The regression analysis of the toluene results from the PID and the reference method results indicated that the measurements were significantly correlated (r2 = 0.93). Conclusion: According to the results, the device response is linear. Therefore, the findings are acceptable in adsorption studies. In this way, the measurement of the sample concentration should be performed using the same instrument before and after the reactor in order to calculate the adsorption efficiency.
Authors and Affiliations
Amir Hossein Khoshakhlagh, Farideh Golbabaei, Mojtaba Beygzadeh, Francisco Carrasco-Marín, Seyed Jamaleddin Shahtaheri
Keywords
Related Articles
- EP ID EP695565
- DOI 10.34172/EHEM.2021.15
- Views 126
- Downloads 0
Physicochemical transformation of ZnO and TiO2 nanoparticles in sea water and its impact on bacterial toxicity
Background: The enormous properties of metal oxide nanoparticles make it possible to use these nanoparticles in a wide range of products. As their usage and application continue to expand, environmental health concerns h...
Swot analysis of factors causing air pollution and recommended control efforts in the city of Yogyakarta, Indonesia
Background: Knowing the root causes of air pollution in urban areas will determine the next actions to take. Analyzing the impact caused by air pollution will make it easier to determine the control efforts to be carri...
Estimation of average annual soil loss rates and its prioritization at sub-watershed level using RUSLE: A case of Finca’aa, Oromiya, Western Ethiopia
Background: Because of natural and anthropogenic phenomena, most mountain areas experience significant soil loss. It is critical for watershed management to identify high soil loss rates and prone areas. Therefore, the...
The use of a pumice stone in removal of petroleum hydrocarbons from industrial wastewater through coagulation and flocculation
Background: Petroleum hydrocarbons that are released from industrial processes cause damage to aquatic life and degrade ecosystems by accumulating in the food chain, allowing living organisms to produce toxic secretion...
Assessment of ecological risk and identification sources of polycyclic aromatic hydrocarbons at coastal sediments: A case study in Bushehr Province, Iran
Background: Polycyclic aromatic hydrocarbons (PAHs) are stable and highly toxic environmental pollutants, which are produced mainly through combustion processes. The present study aimed to identify and determine PAHs com...