EXECUTIVE DISADVANTAGES IN THE LAYERED WALL OF THE FACADE
Journal Title: Civil and Environmental Engineering Reports - Year 2016, Vol 3, Issue 22
Abstract
In this paper a case of three-layer wall and fitting windows is described. The walls outside layer are made of clinker brick. The public basis is a situation, which occurred in an office building. In this building was a water stain on the windows inside the upstairs part the building, during the rain. In project of the building there were no details of performing three-layer wall and fitting of windows. In Poland one did not described in detail the realization for windows installation in three-layer wall.
Authors and Affiliations
Elżbieta GROCHOWSKA, Antoni MATYSIAK
Keywords
Related Articles
- EP ID EP243205
- DOI -
- Views 56
- Downloads 0
IMPACT OF DEVELOPMENT OF INFRASTRUCTURE FOR CHARGING ELECTRIC VEHICLES ON POWER DEMAND IN THE NATIONAL POWER SYSTEM
The following paper focuses on the electric vehicles sector development and its possible influence on power system load in Poland. The goal is to estimate the increase of power demand resulting from the electric cars cha...
Gasification process as a complex method of sewage sludge treatment
Today, there is a rising interest in many countries in “traditional” (e.g. agro and forest) biomass and waste biomass (e.g. sewage sludge) utilization processes (e.g. combustion, co-combustion, gasification and pyrolysis...
EFFECTIVENESS OF ASSESSING FLOOD HAZARDSALONG THE LUBUSKI SECTION OF THE ODER
One of the major problems connected with the management of the Oder riverbasin is an effective protection against floods. In the region of Środkowe Nadodrze (Middle Oder Land) it has been done, among others, by means of...
ZAHN-WELLENS TEST IN INDUSTRIAL WASTEWATER BIODEGRADABILITY ASSESSMENT
Biodegradability of pollution contained in examined industrial wastewater was assessed according to methodology based on Zahn-Wellens (OECD 302B) test. The following kinds of wastewater were examined: - metal industry wa...
Application of fundamental solutions to the static analysis of thin plates subjected to transverse and in-plane loading
In this paper static analysis of Kirchhoff plates is considered. A transverse and in-plane loading is taken into consideration. The Finite Strip Method is used and the suitable fundamental solutions are applied. Accordin...