Experimental Investigation of Twisted Tape Insert in a Double Pipe Heat Exchanger using Aluminium Oxide Nanofluid
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2019, Vol 9, Issue 5
Abstract
This document reports on the experimental investigation of the features of the heat transfer performance of heat exchanging device with tape insert. The experimental investigation was carried out pipe a warped tape inserted with a proportion of 4.8. An experimental heat flow investigation analyzed using Al2O3 water-based Nanofluids was used in this work. The experiment was performed in a turbulent flow situation with a twisted tape of simple water and Nano liquids. Experimental data on plain water and nanofluid was drawn and these informations were used to correlate with plain water and nanofluid. Experimental data were generated with water and nano-fluid for Reynolds in the variety 110000–135460, Nu nanofluid based water. A heat flow features Al2O3 and simple stream were improved an augment Re. An experimental data nano fluid was increased by 2.89% compared to the experimental value of plain water. The findings of the inquiry indicate the performance improvement of the parameters of the heat exchanger, namely, the coefficient of heat flow augment by means of amount absorption of the nanoparticle compare with water.
Authors and Affiliations
T. Mohankumar, K. Rajan
Keywords
Related Articles
- EP ID EP672223
- DOI 10.24247/ijmperdoct201944
- Views 97
- Downloads 0
AN EXPERIMENTAL STUDY AND PARAMETRIC OPTIMIZATION OF AWJC ON ALUMINIUM 7075 ALLOY
Abrasive waterjet cutting is a non-traditional cutting processes capable of cutting wide range materials. This report assesses the influence of process parameters on surface roughness which is an important cutting perfor...
Energy Output Evaluation from Aphotovoltaic System at Different Selected Sites in Jordan
Solar energy is one of the best solutions for Jordan energy problems, as Jordan is a sunny country with 300 sunny days over the year. This study presents a calculation of the energy output from a PV system at six selecte...
Influence of Addition of Silicon on Mechanical Properties of Aluminium - Zinc Alloy
In this investigation, the experiment was conducted to analyze the mechanical properties such as Yield Strength, Ultimate Tensile Strength, Hardness on Al-Zn alloy of different composition Specimen 1 (89.4%Al4%Zn1%Mg0.6%...
Experimental Investigation of Spring Back and Wrinkling Phenomena in Square Pipes during Bending
Bending operation is one of the crucial steps in producing a variety of industrial products. The objective of this work is to design and fabricate a pipe bending die for making square shaped pipes. Design of the die is d...
Parametric Study in Surface Finishing of Inconel 718 Surface with Magnetic Abrasive Finishing Process
Inconel 718 is a nickel based alloy, used in high pressure and temperature applications, due to its high strength and thermal resistance properties. Machining of Inconel 718 is very difficult due to its toughness. Surfac...