EXTENSION OF A PHASE TRANSFORMATION MODEL FOR PARTIAL HARDENING IN HOT STAMPING
Journal Title: Journal of Machine Engineering - Year 2018, Vol 18, Issue 3
Abstract
The quality of predicted microstructural and mechanical properties in hot stamping simulations relies considerably on the material model. Many researchers studied the effect of the plastic deformation on the phase transformation of the most commonly used hot stamping steel 22MnB5, and proved that the deformation applied at high temperature promotes the formation of ferrite, pearlite and bainite. This behaviour has to be integrated into materials modelling. In this study, the effect of pre-strain on the phase transformation of the material is considered. The specimens are heated to austenitization temperature, isothermally deformed at 700 °C, and quenched down to room temperature. The phase fractions and the temperature-dilatation behaviour obtained from the experiments are used to calibrate the material model. By using the experimental data obtained from dilatometer testing, the accuracy of the material model is evaluated. Additionally, an attempt to predict the results between the tested data points by using interpolation was made and compared with the simulation results.<br/><br/>
Authors and Affiliations
Thawin HART-RAWUNG, Johannes BUHL, Markus BAMBACH
Keywords
Related Articles
- EP ID EP376420
- DOI 10.5604/01.3001.0012.4619
- Views 60
- Downloads 0
IN-PROCESS MONITORING AND ANALYSIS OF DYNAMIC DISTURBANCES IN BORING AND TREPANNING ASSOCIATION (BTA) DEEP DRILLING
This paper presents an approach to monitor the dynamic disturbances of a BTA (boring and trepanning association) deep drilling system. High length to diameter ratios are the key characteristic of deep drilling processes...
INCREASING PRODUCTIVITY OF CUTTING PROCESSES BY REAL-TIME COMPENSATION OF TOOL DEFLECTION DUE TO PROCESS FORCES
The Internet of Production (IoP) describes a vision in which a broad range of different production data is available in real-time. Based on this data, for example, new control types can be implemented, which improve indi...
CONTEMPORARY CHALLENGES IN TOOL CONDITION MONITORING
Implementation of robust, reliable tool condition monitoring (TCM) systems in one of the preconditions of introducing of Industry 4.0. While there are a huge number of publications on the subject, most of them concern n...
COMPARISON OF CLASSIFICATION ABILITY INDICES OF PARAMETERS CHARACTERIZING THE STEREOMETRIC FEATURES OF TECHNICAL SURFACES
The study examined the relationship between the values of two indices evaluating the classification capacity of parameters characterizing the stereometric features of technical surfaces. The values of 83 3D parameters ch...
DEVELOPMENT OF ENVIRONMENTALLY-FRIENDLY TECHNOLOGIES BASED ON THE DOUBLE-ECO MODEL -AN EVALUATION PLATFORM
In recent years, the urgency to create environmentally-friendly technologies has dramatically increased. However, these technologies are usually not adopted due to their large cost and low profit. Previously the “Double-...