Fast Protection of Power System Using Pll and Fuzzy Logic Controller
Journal Title: International Journal for Research in Applied Science and Engineering Technology (IJRASET) - Year 2015, Vol 3, Issue 6
Abstract
In this paper a new method is proposed that can be used to differentiate faults from switching transients. The method is primarily intended for use in systems where fast fault detection and fast fault clearing before the first peak of the fault current are required. An industrial system, in which high short-circuit power is desired but in which high short circuit currents cannot be tolerated is an example of such a strong power system. A phase-locked loop (PLL) with FLC is used to perform the discrimination. Computer simulations have been performed and it has been demonstrated that the output of the PLL is completely different for a fault compared to a switching transient. This difference can be used for discrimination between a fault and a switching transient. The simulation work has been performed using MATLAB software.
Authors and Affiliations
K. Sanath Kumar, M. Prasad
Keywords
Related Articles
- EP ID EP21031
- DOI -
- Views 300
- Downloads 3
Experimental Behavior of Full Encased Composite Column under Axial Compression
This paper presents the experimental behaviour of full encased composite columns (FECC) under axial compression. A composite column is a column in which steel section is embedded into concrete with longitudinal reinforc...
A Study on Effective Algorithm for Medical Decision Making System
This research is to search for alternatives to the resolution of complex medical diagnosis where human knowledge should be apprehended in a general fashion. Successful application examples show that human diagnostic cap...
A Survey About MANET
Our aim in this paper to take a survey about MANET. That is by collecting the information of transmission capacity and packet delivery delay in mobile ad hoc networks. In order to achieve the fundamental understanding o...
slugA Survey– Algorithm For Fault Node Recovery For Wireless Sensor Network
Fault node recovery algorithm is used to increase the life time of wireless sensors network when some node stop working or found to be faulted .This algorithm is a combination of grad...
Computational Fluid Dynamics Analysis of Single Pass Shell & Tube Heat Exchanger with Different Orientation of Baffles and Without Baffles
In this specific project an endeavor is design for CFD evaluation of Single Pass Shell & Tube Heat Exchanger with Different Orientation of Baffles and Without Baffles with counter flow of fluid. In order to research the...