Film disk resonators based on magnetostatic oscillations for microwave generators
Journal Title: Вісник НТУУ КПІ. Серія Радіотехніка, Радіоапаратобудування - Year 2011, Vol 0, Issue 44
Abstract
The guidelines for building walk-through disk resonators based on magnetostatic oscillations, discs which are made by etching of epitaxial yttrium iron garnet film, intended for use as the frequency-sets element of microwave oscillator, constructed by the ring scheme. Experimental studies have established that, at nearly twice the restructuring of the resonant frequency, resonators have Q-factor of at least 1000, and it increases with frequency. Since the construction of new disco film resonator is planar, it allows you to combine them into a single planar structure with a microwave amplifier for the construction of a ring oscillator circuit with an electrical microwave frequency tuning.
Authors and Affiliations
E. Kudinov
Keywords
Related Articles
- EP ID EP309400
- DOI 10.20535/RADAP.2011.44.89-95
- Views 59
- Downloads 0
Radio technical characteristics of loop plasma antennas
Influence of mercury vapors in the frequency range 50-500 MHz on the specific conductivity (SC) of cold plasma of gas discharge by the loopback asymmetrical PA is probed. It is shown that in the injection of mercury vapo...
Method for enhancing the reliability of information telecommunication clouds through the introduction of homogeneity
The approach to the information cloud design through the introduction of homogeneity is presented in the article. The method that is excluding single points of failure is considered in the article. The usage examples and...
The credit-module system in the technical education – tests and proposes
Problems, which need to decide with using of the credit-module system in the technical education in Ukraine, are discussed. The ways of the decision of these problems are regards and proposed
High-Q spherical dielectric resonator oscillations in the optical and infrared ranges
It’s provided the analysis results for the dielectric Resonators electromagnetic parameters with low permittivity dielectric in the optical and infrared wave-length ranges. The frequencies and Q-factors of the spherical...
Methodology for determining the reliability of fault-tolerant hardware-software radioelectronic systems
Introduction. The majority of radioelectronic systems are hardware-software systems. Their reliability is defined as the reliability of hardware and software. Methods for estimating software allow to predict reliability...