Hydrogen sulfide and organic compounds removal in municipal wastewater using ferrate (VI) and ultraviolet radiation
Journal Title: UNKNOWN - Year 2017, Vol 4, Issue 1
Abstract
Abstract Background: In this study, ferrate (VI) and ultraviolet (UV) radiation were employed to remove hydrogen sulfide from municipal wastewater resulting in a reduction in chemical oxygen demand (COD). Although ferrate (VI) and UV have been used individually for the removal of a few pollutants from urban and industrial wastewater, there exists no study to investigate the effectiveness of simultaneous utilization of both methods for the removal of hydrogen sulfide and reducing COD. Methods: This study aims to compare the application of UV, ferrate (VI) and UV/ferrate (VI) for the removal of hydrogen sulfide and COD from municipal wastewater in batch mode. Moreover, the effect of many parameters such as ferrate (VI) concentration, temperature, hydraulic retention time (HRT) and pH on ferrate (VI) oxidation power, were investigated. Results: The results of this study demonstrated that for pH less than 2, higher pollutant removal efficiency was obtained. COD removal efficiency could increase up to 68% by adding 1.68 mg/L of ferrate (VI), almost 100% of hydrogen sulfide was removed by the same concentration of ferrate (VI). Both hydrogen sulfide and COD removal efficiencies increased as temperature increased to 50°C; nevertheless, further increase in temperature had negative effect on the removal efficiency. The use of UV/ferrate (VI) increased the removal efficiency of both hydrogen sulfide and COD when compared with the use of UV and ferrate (VI) individually. UV method was not effective in the removal of hydrogen sulfide. Conclusion: The research findings shed new light on wastewater treatment systems employing UV/ ferrate (VI) to decrease both the hydrogen sulfide and COD of municipal wastewater. This new findings will assist in the inaccurate design and effective operation of such systems which can be employed to maintain or improve environmental quality.
Authors and Affiliations
Amirreza Talaiekhozani
Keywords
Related Articles
- EP ID EP284216
- DOI 10.15171/EHEM.2017.02
- Views 87
- Downloads 0
Emission evaluation of CO2 and CH4 gases in the selected gas pressure booster station in the Bangestan field of the National Iranian Oil Company
Background: Iran is located in the seventh rank in terms of CO2 emissions resulting from the fuel combustion in the world. Gas compressor booster stations, due to the several sources of contaminants, are causing the rele...
Biomedical waste disposal systems of health facilities in Ethiopia
Background: Biomedical waste generated from health and health-related activities can be grouped as general waste and hazardous waste. This remains true if and only if there is proper on-site handling, such as the segrega...
Drying of Urmia Lake: modeling of level fluctuations
Background: Urmia Lake, the second largest hyper-saline lake of the world, has experienced lack of water and other environmental issues in recent years. Now, there is a danger of the lake drying out, which will affect th...
Prediction and modeling of fluoride concentrations in groundwater resources using an artificial neural network: a case study in Khaf
Background: One issue of concern in water supply is the quality of water. Measuring the qualitative parameters of water is time-consuming and costly. Predicting these parameters using various models leads to a reduction...
Adsorption of copper, lead and cadmium from aqueous solutions by activated carbon prepared from saffron leaves
Background: Industrial development has caused the release of various pollutants including heavy metals into the environment. These toxic compounds are extremely dangerous to living beings and the environment due to their...