IDENTIFICATION OF PHASE TRANSFORMATION MODEL FOR THE SIMULATION OF CONTROLLED COOLING OF BAINITIC STEEL TUBES
Journal Title: Prace Instytutu Metalurgii Żelaza - Year 2018, Vol 70, Issue 4
Abstract
JMAK (Johnson-Mehl-Avrami-Kolmogorov) equation was adapted to simulation of phase transformations during cooling of bainitic steel tubes. The model was identified on the basis of the results obtained from the JMatPro software. Numerical tests for various cooling schedules showed model’s capability to predict a volume fraction of microstructure constituents of the tubes. The model was implemented into FE code for the simulation of tubes cooling. For the sake of the model capabilities, three cooling methods were considered: (i) free cooling in the air, (ii) cooling with the pressurised air, (iii) cooling with the water mist. Both symmetrical and asymmetrical cooling conditions were considered. The volume fractions of the tube’s microstructure constituents were calculated for each cooling conditions.
Authors and Affiliations
Roman Kuziak, Krzysztof Radwański, Ryszard Molenda, Artur Mazur, Józef Broll, Maciej Pietrzyk
Keywords
Related Articles
- EP ID EP481356
- DOI 10.32730/imz.0137-9941.18.4.2
- Views 84
- Downloads 0
EKSPLOATACJA RUROCIĄGÓW PARY – DIAGNOSTYKA I WNIOSKI EKSPLOATACYJNE
Materiały konstrukcyjne bloków energetycznych są eksploatowane w warunkach długotrwałego oddziaływania zmiennych pól naprężeń i temperatur oraz są narażone na oddziaływanie środowiska gazów i cieczy. Czynniki te powodują...
EFFECT OF AUSTENITISING ON THE STRUCTURE AND PROPERTIES OF LOW-ALLOY Cr-Mo-V STEELS AFTER LONG-TERM OPERATION IN CREEP CONDITIONS FOR THE POWER INDUSTRY
The article concerns the revitalising heat treatment of components of the pressure part of power units operating under creep conditions. The possibilities of “recovering” the structure and functional properties similar t...
RESIDUAL LIFE OF REPAIR WELDED JOINTS IN PIPELINES MADE OF 13HMF AFTER USE FOR THE DESIGN OPERATING TIME
This paper presents the results of material tests of repair welded joints carried out for samples of materials taken from high pressure steam pipelines after over 200,000 operating hours in creep conditions, made of the...
MICROSTRUCTURE AND MECHANICAL PROPERTIES OF A SIMILAR T24 STEEL WELDED JOINT AFTER SERVICE
The material under investigation was a welded joint made of 7CrMoVTiB10-10 (T24) steel after 36,000 hours of use at the temperature of 540°C and pressure of 27 MPa. The test samples for the study were taken from a membra...
Forecasting the development of the national construction market in terms of the economic crisis
The paper considers the main problems in the construction market in Ukraine economic crisis and analyzes the structural problems of the industry, studied the experience of transformation construction industries in oth...