IMPLEMENTING A SPC INTEGRATED SYSTEM TO IMPROVE MANUFACTURING PROCESSES IN AUTOMOTIVE INDUSTRY
Journal Title: TEHNOMUS - Year 2011, Vol 18, Issue 1
Abstract
Nowadays challenges emphasize greatly on the accomplishment of a high level of quality in manufacturing processes, especially in automotive industry. Various methods have been used in order to find ways to organize monitor and control the manufacturing processes. A method used widely to achieve these equirements is statistical process control (SPC). The objective of this study is to present a system which integrates SPC with the results from 3D measuring systems in order to calibrate and monitor manufacturing processes from an automotive industry organization. The implementation of the integrated system has resulted in improvement of the manufacturing processes and, consequently, to a better quality of the final products.
Authors and Affiliations
L. Lobont, C. V. Kifor, C Oprean, O. Suciu
Keywords
Related Articles
- EP ID EP150321
- DOI -
- Views 91
- Downloads 0
RESEARCH ON STRESS AND DEFORMATION STATE IN PLASTICAL BENDING WITH STRETCHING
The paper presents a theoretical solution of the stress and deformation state in plastically bending with stretching. It was established calculus relations of the neutral layer relative displacement coefficient, bending...
DETERMINATION OF THE EFFORTS THAT OCCUR IN THE CASE OF PERFORMING INNER THREADS WITH FORMING ROLLERS
The aim of this paper is to present a simplified model for the theoretical calculation of the deformation efforts that occur in the case of performing inner threads by forming rollers. Firstly, determination of the norma...
AN INTELLIGENT SYSTEM SEARCH FOR INDOOR COLOR RECOGNITION: A COMPARISON
This work addresses a map-based method for the localization of mobile robots (wheeled or legged) in indoor environments, using monocular vision. This method is comprised of four stages: image acquisition, image feature e...
RESEARCHES ON THE INFLUENCE OF ELECTRICAL PARAMETERS OF CIRCUIT ON DEPTH OF DRAWING OF CIRCULAR PARTS THROUGH ELECTRO-HYDRAULIC PROCESS
This paper deals with the influence of the discharge electrical parameters such as wire length and diameter priming discharge, discharge capacity and battery voltage on the stamped depth to electrohydraulic method
ABOUT NATIONAL STRATEGY OF ROAD SAFETY IN PRESENT AND FUTURE
After the year 1990, the car park and also the number of drivers have almost tripled, being in a complete contradiction with the slow development of the infrastructure, leading to an increase in the percent of material a...