Influence of Workpiece Hardness on Tool Wear in Profile Micro-milling of Hardened Tool Steel
Journal Title: Tribology in Industry - Year 2018, Vol 40, Issue 1
Abstract
Machining of engineering metallic materials on micro-level is very complicated. Micro-milling with solid tools, as one of microengineering technologies, is an acceptable process to machining of complex metallic micro-parts. The main problem in micro-milling is sensitivity of cutting tool, due its suppleness and short tool life, and its influences to workpiece accuracy and quality. In this paper is experimentally investigated tool wear of micro-milling tool. During machining tests, influence of workpiece hardness and process parameters is evaluated. Workpiece was cold work alloyed tool steel X155CrVMo12, hardened to different hardness 45, 54 and 63 HRc. Cutting tool was carbide ball-end micro-mill with TiAlN coating, and diameter of 0.6 mm. For different combination of input parameters, tool wear curves is presented, and signification of input parameters on tool wear is evaluated and discussed.
Authors and Affiliations
B . Sredanović, G . Globočki Lakić, D . Kramar, F. Pušavec
Keywords
Related Articles
- EP ID EP276120
- DOI 10.24874/ti.2018.40.01.09
- Views 84
- Downloads 0
Evaluation of the Spread Range of 3D Parameters for Coated Surfaces
3D measurement on surface roughness could be used to assess the surface quality but the procedure is time-consuming and the better the equipment and its performances, the smaller the investigated surfaces. There were inv...
Development of Asbestos - Free Brake Pad Using Bagasse
Development of asbestos-free brake pad using bagasse was investigated with a view to replace the use of asbestos whose dust is carcinogenic. The bagasse were sieve into sieve grades of 100, 150, 250, 350 and 710μm. the s...
Modeling for Friction of Four Stroke Four Cylinder In-Line Petrol Engine
A four stroke four cylinder in-line petrol engine is modeled to estimate various performance parameters. The solution is based on tribology and dynamics principle. The detailed parameters related to engine friction and l...
Heat Generation During Friction Stir Welding Process
Friction stir welding – FSW was a promising welding technology from the same moment of its existence because of its easy use, low energy costs, being ecology friendly process and with no need for filler metal. FSW works...
Wear Analysis of Top Piston Ring to Reduce Top Ring Reversal Bore Wear
The piston rings are the most important part in engine which controls the lubricating oil consumption and blowby of the gases. The lubricating film of oil is provided to seal of gases towards crankcase and also to give s...