Investigation of influence of the metal corrugated pipe diameter on its stress-strain state
Journal Title: Вісник Тернопільського національного технічного університету - Year 2018, Vol 91, Issue 3
Abstract
Metal corrugated structures require both high design quality and quality of construction. Significant contribution to the damage initiation and the MCS fracture can be caused by the imperfect methods of calculating MCS in the soil environment and incorrect choice of the structure span, as well as the shape of the structure cross-section. The problems of adaptation of foreign standards concerning the design of metal corrugated structures on the railway and motor roads of Ukraine are analyzed, the results of experimental and theoretical calculations of bearing capacity of metal corrugated structures are presented. It was determined, that the stresses arising in the pipe metal sheets of 1 m till 9 m diameter do not exceed the metal ultimate elasticity of 235 MPa. However, for the 10 m diameter pipe the stresses value exceeds the permissible value of the metal pipe yield strength of 235 MPa. It is established, that for the pipes of 1 m till 9 m diameter the value of the plastic hinges formation does not exceed the permissible value of 1,0. However, for the 10 m diameter pipe the value of the plastic hinge formation ratio is 1,531, which is unacceptable for this steel grade. Since in the 10 m diameter pipe due to the load from the locomotive 2M62 the plastic deformations are formed in the metal pipe, it can cause the destruction of the transport structure as a result.
Authors and Affiliations
Josyp Luchko, Vitalii Kovalchuk, Ivan Kravets
Keywords
Related Articles
- EP ID EP438039
- DOI 10.33108/visnyk_tntu2018.03.026
- Views 56
- Downloads 0
The stress state of orthotropic shell with two collinear cracks of different lengths under bending load on the lines
In this paper we present the analytically and numerically study of the problem of the stress state of the shallow orthotropic dual curvature shell with two collinear rectilinear through thickness cracks of different leng...
Ways to improve Fourier series convergence and its application for Laplace numerical inversion
The solution of a wide class of the problems of mathematical physics can be obtained in the form of Fourier series. When considering the problems, concerned with study of the localized actions, the quickchanging solution...
Physical-chemical regularities of steel refining from non-metallic inclusions
Using the thermodynamic analysis, the possibility of a colloid interaction of the dispersed phase with a dispersed medium, the possibility of coagulation of the non-metallic phase, has been determined. It is established,...
Autonomous power supply system for outdoor illumination of residential areas in the territory of Ukraine
The methodology and the calculation of the autonomous power supply system for outdoor illumination using solar batteries of KV 250M type, Li-ion batteries of LP48100ES type and the control system consisting of the MPPT c...
Properties of esr steel, melted to a bifilar scheme using hard start correspond
The properties of cast electroslag steel 5XНM made to a bifilar scheme using a hard start correspond to the properties of the cast metal melted openly and allow to use die blocks instead of forged ones. It is experiment...