INVESTIGATIONS ON TORSION OF THE TWO-CHORDS SINGLE LACED MEMBERS
Journal Title: Civil and Environmental Engineering Reports - Year 2017, Vol 2, Issue 25
Abstract
The paper presents experimental and numerical studies to determine the equivalent second moment of area of the uniform torsion of the two-chord steel single laced members. The members are used as poles of railway traction network gates, and steel columns of framed buildings as well. The stiffness of uniform torsion of this kind of columns allows to the determine the critical loads of the spatial stability. The experimental studies have been realized on a single - span members with rotation arrested at their ends, loaded by a torque applied at the mid-span. The relationship between angle of rotation of the considered cross-section and the torque has been determined. Appropriate numerical model was created in the ABAQUS program, based on the finite element method. A very good compatibility has been observed between experimental and numerical studies. The equivalent second moment of area of the uniform torsion for analysed members has been determined by comparing the experimental and analytical results to those obtained from differential equation of non-uniform torsion, based on Vlasov’s theory. Additionally, the parametric analyses of similar members subjected to the uniform torsion, for the richer range of cross-sections have been carried out by the means of SOFiSTiK program. The purpose of the latter was determining parametrical formulas for calculation of the second moment of area of uniform torsion.
Authors and Affiliations
Paweł LORKOWSKI, Bronisław GOSOWSKI
ANALYSIS OF CHANGES TO STEEL FOOTBRIDGE GEOMETRY WITHIN 25 YEARS IN SERVICE
Identification of the technical condition of bridge structures should be supplemented by determination of structural displacements in relation to the adopted frame of reference and measurement of changes to the geometry...
ULTRASONIC INTENSIFICATION OF AEROBIC STABILIZATION OF SEWAGE SLUDGE
The aerobic stabilization of excess sewage sludge using low frequency ultrasound (25kHz) was investigated. The mechanically thickened excess sludge was obtained from full-scale wastewater treatment plants. The samples of...
TRUSS JOINT WITH POSITIVE ECCENTRICITY EXPERIMENTAL RESEARCH
TRUSS JOINT WITH POSITIVE ECCENTRICITY EXPERIMENTAL RESEARCH
DESIGN AND CONSTRUCTION PROBLEMS CONNECTED WITH ENSURING EVEN THERMAL INSULATION OF SINGLE-LAYER WALLS
The design of single-layer walls appears to be extremely simple. In the opinion of many designers, the additional insulation of tie beams and balconies continues to solve all problems. However, tests on single-layer wall...
Non-stationary heat transfer in two-phase hollow cylinder with functionally graded effective material properties with second kind of boundary conditions
The unidirectional non-stationary heat conduction in two-phase hollow cylinder is considered. The conductor is made of two-phase stratified composites and has a smooth gradation of effective properties in the radial dire...