LABORATORY STAND FOR SMALL WIND TURBINE SIMULATION
Journal Title: Informatyka Automatyka Pomiary w Gospodarce i Ochronie Środowiska - Year 2017, Vol 7, Issue 4
Abstract
The article presents a concept of the laboratory stand for wind turbine simulation, built on the basis of cage induction motor, supplied from a frequency converter. The model assumes control of the engine torque, using simple constant Volt/Hertz control with slip regulation, taking into account the moment of inertia of the simulated turbine. Performance of the system for different wind and generator load conditions has been shown. Test results proved, that the turbine torque is well tracked by the wind motor emulator.
Authors and Affiliations
Wojciech MATELSKI, Eugeniusz Łowiec, Stanisław ABRAMIK
WIELOWARIANTOWA ANALIZA POLA MAGNETYCZNEGO I OBLICZENIE SIŁ LEWITACJI AKTYWNEGO OSIOWEGO ŁOŻYSKA MAGNETYCZNEGO (AAMB)
W artykule przedstawiono wielowariantowe obliczenia pola i siły magnetycznej siłownika aktywnego osiowego łożyska magnetycznego (AAMB). Wykonano model polowy oparty na Metodzie Elementów Skończonych (MES), który pozwolił...
APPLIED GLONASS OBSERVATIONS IN PPP METHOD IN AIRBORNE TEST IN MIELEC
Article presents research results concerning to determination Cessna 172 plane position using PPP method for code and phase observations in GLONASS system. The aircraft’s coordinates were estimated in CSRS-PPP and m...
POMIAR WSPÓŁCZYNNIKA PRZEWODNOŚCI CIEPLNEJ WŁAŚCIWEJ CIECZY ELEKTROIZOLACYJNYCH Z WYKORZYSTANIEM AUTORSKIEGO UKŁADU POMIAROWEGO
W artykule przedstawione zostały wyniki pomiarów współczynnika przewodności cieplnej właściwej wybranych cieczy elektroizolacyjnych w zależności od temperatury. Określona została wartość współczynnika przewodności ciepln...
COMPARISION OF SELECTED FLAME AREA DETECTION METHODS IN VISION DIAGNOSTIC SYSTEM
This paper presents comparison edge detection method of combustion pulverized coal. Compared method are: Canny edge detection operator, level set method and Chan-Vese active contour method. Experimental results show that...
BADANIA TEORETYCZNO-EKSPERYMENTALNE PRZEPŁYWU PŁYNU NIEŚCIŚLIWEGO PRZEZ KRYZĘ SZCZELINOWĄ
W praktyce pomiarowej coraz częściej stosuje się prototypowe rozwiązania konstrukcyjne przepływomierzy zwężkowych. Na uwagę zasługują kryzy szczelinowe, gdzie jeden centralny otwór zastąpiony jest szczelinami. W pracy pr...