Linear Model for Turning Al6061 using Least Absolute Shrinkage and Selection Operator (Lasso)
Journal Title: International Journal of Engineering and Science Invention - Year 2017, Vol 6, Issue 7
Abstract
Machining Aluminium to produce low cost and high quality products is the order of the day and the same has seen intense research over the years. Formation of built-up edge has an opposing effect on quality of the workpiece and it can be avoided by careful tuning of the machining parameters. This paper focuses on the optimisation of process parameters such as speed, feed, and the depth of cut in order to minimize the cutting forces and maximise the surface finish of the work piece. A full-factorial approach was used to conduct experimentation and a mathematical model was developed using Least Absolute Shrinkage and Selection Operator to understand the effect of the mentioned process parameters on the required target variables.
Authors and Affiliations
S Gajanana, B SureshKumar Reddy, A Krishnaiah
Keywords
Related Articles
- EP ID EP403268
- DOI -
- Views 90
- Downloads 0
CeO2 activated ZnO-TiO2 thick film for CO2 gas sensor
Nanocrystalline ZnO-TiO2 (molar ratio 9:1, 7:3, 1:1, 3:7 and 1:9) synthesized by hydrothermal method. The synthesized materials were used to prepare the thick films and gas sensing characteristics of prepared thick films...
A Case Study of Structural Failure of Mounting Systems for Solar Panels from South-Eastern Turkey: An Investigation of Design Parameters under Extreme Weather Events
One of the biggest demand of growing population, and cornerstone of the socio-economical growth of Nations, Energy is expected today to be Sustainable, Easy to Reach, Economical, and Continuous. As one of the most common...
The Characteristics and Content of Thermal Water and Their Impact in DibërArea
One of the objectives of this study has been the analyzing and defining of the content and the characteristics of thermal water in Diber, Albania, and their impact in the area. This study has been organized during years...
Experimental Study On The Purification Of Carbon Nanotubes Using Carbon Dioxide Gas As An Oxidation Reagent
The fabrication and application of carbon nanotubes (CNTs) have been strongly investigated and developed recently. However, the application of CNTs usually encounters a great limitation that the unique properties of CNTs...
Vision Based Fire Detection System
Detecting The Presence Of Fire In Images And Videos Can Be A Very Helpful Technique.Once This Technique Is Honed And Works Well, It Has The Potential To Save Not Only Lives, Butalso Property Such As Office Buildings, Sch...