Low Voltage Mixed-mode Multi Phase Oscillator Using Single FDCCII
Journal Title: Elektronika - Year 2016, Vol 20, Issue 1
Abstract
In this paper a new low voltage mixed-mode multiphase quadrature oscillator employing a single fully differential second generation current conveyor, two resistors and two grounded capacitors is proposed. The proposed circuit provides two quadrature voltage outputs and three quadrature current outputs simultaneously. In addition, the proposed circuit has been made load insensitive so that it is capable of providing high output impedance current outputs without using additional current followers. Moreover, the proposed circuit of load insensitive quadrature oscillator provides four phase current outputs and two voltage outputs, simultaneously. Non-ideal study is also included. Both the proposed circuits enjoy low active and passive sensitivities. This paper further presents an active-C multiphase oscillator with a single FDCCII and two grounded capacitors. The proposed structures are suitable for low voltage applications. Simulation results using PSPICE program on cadence tool are included.
Authors and Affiliations
Jitendra Mohan, Bhartendu Chaturvedi, Sudhanshu Maheshwari
Keywords
Related Articles
- EP ID EP362530
- DOI 10.7251/ELS1620036M
- Views 101
- Downloads 0
Research Issues in DFIG Based Wind Energy System
Among different renewable energy sources, Wind energy is the most imperative energy source in power system. The development of grid connected wind energy conversion system expands, its grid connectivity issues has additi...
Some examples of photorefractive oscillators
The photorefractive effect presents a periodical change of the refractive index of an optical environment under the influence of a coherent light. An interesting phenomenon which occurs at this effect is optical phase co...
Position Measurement over Wide Range by Simultaneous Use of Low and High Coherence Light Source
In this paper we propose and experimentally demonstrate a new technique for position/displacement measurement using fiber optic interferometry. We simultaneously employ a low- and a high- coherence light source in the sa...
Measuring Capacitor Parameters Using Vector Network Analyzers
Vector network analyzer (VNA) is versatile measuring equipment which is primarily used for two-port device S parameters measurements. This paper addresses measurement of capacitor parameters using VNA in broad frequency...
An improved implementation of hierarchy array multiplier using CslA adder and full swing GDI logic
In this paper, an efficient implementation of a 16 bit array hierarchy multiplier using full swing Gate Diffusion Input (GDI) logic is discussed. Hierarchy multiplier is attractive because of its ability to carry the mul...