Mechanistic Modeling of Run out, Ovality and Misalignment in Reaming Process
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2019, Vol 9, Issue 5
Abstract
Common process faults during reaming operations are runout, ovality and misalignment which leads to an increase in dynamic cutting forces during the reaming operation. This paper presents computation of cutting forces through the mechanistic modeling with process faults. Simulated results and experimental results were obtained for different materials and presented in the paper. For the experimentally obtained dynamic forces, process faults were manually given on the workpiece and dynamic forces were obtained. The Deckel Maho milling machine and kistler dynamometer are used for experimental work.
Authors and Affiliations
Dr. Raghavendra Kamath. C, Appu Kuttan
Keywords
Related Articles
- EP ID EP672295
- DOI 10.24247/ijmperdoct201982
- Views 90
- Downloads 0
Experimental Investigation on Linseed Oil Methyl Ester Fuelled Diesel Engine
The look for an alternative fuel has prompted numerous discoveries because of which a wide assortment of alternative energizes are accessible available to us now. On the basis of fossil fuel energizes around the world ne...
Investigation of Microstructural and Metallurgical Properties of Corten A588 Grade Steel GTAW Joint
Corten A588 steel is a high strength low alloy structural steel having 0.19% wt of carbon content. It has good corrosion resistance when exposed to extreme atmospheric conditions. Corten steel weighs less than other grad...
The Design and Analysis of Piston - Steady State Thermal Analysis using “Ansys”
In this study thermal analysis on piston made of aluminium alloy are absorbed Internal combustion engines have been a relatively inexpensive and reliable source of power for applications ranging from domestic use to larg...
Comparing the Effect of Heat Treatment and Plasma-Nitriding on Corrosion Resistance of Ni-B-CNT Electroless Coating with Different CNT Concentration on Aisi 4340 Steel
The aims of the work to study the resistance of corrosion and the hardness of plasma-nitrating and heat treatment of coatings with electroless Ni-B-CNT. Various concentration of CNT range, (0, 0.35 and 0.7)g/L in Ni-B-CN...
Damage to Seeds by the Working Bodies of Continuous Machines
This article deals with the analysis of damaging effect of pre-sowing technological processes on seeds treated with continuous machines, subject to macro and micro damages incurred by the working bodies. Various process...