Optimization of Hole-Making Operations
Journal Title: International Journal of Engineering Sciences & Research Technology - Year 30, Vol 3, Issue 4
Abstract
This paper reports a tabu-search approach to minimize the total manual processing cost for hole-marking operations. on Power Press. Four issues, namely, Manual marking on angle, ideal time of machine while marking, non operating cycle time increase, and tang of production not match with mass production tang. The total processing cost consists of Ideal machining time cost, operates ideal time cost. In addition the problem under consideration is more complex since the cost associated with each operation is both sequence-dependent and position-dependent. To provide an efficient solution procedure, a tabu search approach is used. To improve the search performance two new neighborhood generation and move selection policies have been proposed and tested. The decisions on the above issues can be made simultaneously based on the output of the proposed algorithm. The results obtained from computational experiments show that the total processing cost can be significantly reduced within a reasonable time
Authors and Affiliations
Prof. G. H. Waghmare*1
Keywords
Related Articles
- EP ID EP132835
- DOI -
- Views 76
- Downloads 0
CONFIGURATION AND OPTIMIZATION OF A MICRO STRIP PATCH ANTENNA FOR INCREASED BANDWIDTH
The development of numerous frameworks, it is imperative to plan broadband receiving wires to cover a wide recurrence range. The point of this paper is to plan a broadband patch reception apparatus, utilizing the three...
Critical Event Monitoring in WSNS using Level-By-Level Offset Based Wake up Pattern
This paper proposed to monitor a critical event in wireless sensor networks. Whenever a critical event occurs, the critical event is detected by the nearby sensor nodes. Immediately these sensor nodes should broad...
A REVIEW ON CHANNEL ESTIMATION USING BP NEURAL NETWORK FOR OFDM
OFDM systems are limited by multipath fading. Previously channel estimation was carried out by transmitting pilot symbols in OFDM .The techniques used were comb type pilot arrangement and block type arrangement us...
Selection of Cationic Collector for Reduction of Alumina and Silica in Iron Ore Slimes of an Operating Plant by Flotation
Ultra fines or Slimes generated as overflow in screw classifiers in iron ore washing plants are generally treated in a single or multi-stage hydrocyclones to recover iron values. The underflow of the hydrocyclones forms...
THEORETICAL COMPARATIVE STUDY OF INTERNAL QUANTUM EFFICIENCY OF THIN FILMS SOLAR CELLS BASED ON CuInSe2 : p + /p/n/n+, p/n/n+, p+/p/n and p/n MODELS
In this paper we propose to study the performances of thin films solar cells based on CuInSe2. The following models are studied : p/n ; p+/p/n ; p/n/n+; p+/p/n/n+ .The objective of this work is to study t...