Study of the Effect of Machining Parameters on the Machining Characteristics of Tungsten Carbide in Electrical Discharge Machine
Journal Title: International Journal of Engineering Sciences & Research Technology - Year 30, Vol 3, Issue 7
Abstract
Electrical discharge machining (EDM) is a widely used process in the mould / die and aerospace industries. It is a process for shaping hard metals and forming deep and complex-shaped holes by arc erosion in all kinds of electro-conductive materials. The objective of this research is to study the influence of operating parameters of EDM of tungsten carbide on the machining characteristics. The effectiveness of EDM process with tungsten carbide is evaluated in terms of material removal rate, the relative wear ratio and the surface finish quality of the workpiece produced. It is observed that copper tungsten is most suitable for use as the tool electrode in EDM of tungsten carbide.
Authors and Affiliations
Subhakanta Nayak
Keywords
Related Articles
- EP ID EP89756
- DOI -
- Views 88
- Downloads 0
SPAA AWARE ERROR TOLERANT 32 BIT ARITHMETIC AND LOGICAL UNIT FOR GRAPHICS PROCESSOR UNIT
Arithmetic and logical unit are responsible for all computationally intensive task which determines the speed and reliability of a processor. In other word we can say ALU is the brain of a processor. Nowadays every porta...
CRACKING OF PALM OIL TO PRODUCE OLEOCHEMICALS
The FTIR and GC-MS tests are necessary for identification of oleochemicals produced via cracking. In this research, thermal cracking (without catalyst) and catalytic cracking of palm oil were carried out in a batch reac...
RELIABILITY AND PROFIT EVALUATION OF COMPRESSOR SYSTEM DESCRIBING FAILURES AND DEAL WITH FAILED UNIT ON PRIORITY
The paper presents reliability and profit evaluation of compressor standby system comprising of two units.Initially one unit is operative and the other is in standby state. On failure of any one of the compressor...
USE ROTATIONAL SENSORS AND ACCELERATION IN SMARTPHONE FOR PHASE SPACES
In Todays World The compound system, wheel plus smartphone, defines a physical pendulum which can rotate, giving full turns in one direction, or oscillate about the equilibrium position (performing either small or...
DESIGNING AND ANALYSING DIFFERENT SHAPES OF MEMS BASED ELECTROSTATICALLY CONTROLLED MICROMIRRORS
in adaptive optics and point - to - point communication, various micro mirror devices have been used to reshape the wavefront of a propagating beam to compensate for aberrations in the beam path. Such MEMS mirrors...