On-line Monitoring and Analysis of Urban Rail Transit Stray Current
Journal Title: Urban Mass Transit - Year 2024, Vol 27, Issue 8
Abstract
Objective To ensure the safe operation of underground gas pipeline network near URT (urban rail transit) and to mitigate the electrochemical corrosion on the gas pipeline network caused by URT stray current, it is necessary to conduct online monitoring and analysis of URT stray current. Method Real-time continuous pipe-ground potential data from four monitoring points set up on underground gas steel pipelines near a section of Tianjin URT are obtained. A combined time-frequency domain analysis is conducted on this data. A continuous wavelet transform model is established, and a wavelet power spectrum analysis is performed. Wavelet coherence analysis is utilized to study the coherence degree and phase relationship between pipe-ground potential signals. Result & Conclusion The pipe-ground potential signals under the interference of URT stray current are a typical non-stationary signal, with certain pattern of periodic fluctuations. The intensity of these periodic fluctuations increases non-linearly as the distance to the interference source decreases. The periodically changing pipe-ground potential presents an overall waveform of a mountain-shape parabolic curve, peaking most noticeably within the 64-128 minute range. During URT operation, the coherence intensity between signals shows significant variability, with strong coherence only appearing at some intervals. Additionally, the leading or lagging angles of the inter-signal phase correspond to the operation intervals of URT trains.
Authors and Affiliations
Guoqing YANG, Xuehui MA
Analysis and Solution Schemes for Interference on Metro Signaling System Axle Counting Equipment
[Objective] During the system commissioning, train debugging and trial operation on Chengdu Metro Line 18, the axle counting equipment exhibits AIO (abnormal interference and occupation) due to various disturbances in di...
Acoustic Characteristics Analysis of Rail Transit Vehicle Bogie Axle Box Bearing Faults
Objective To address the challenge of difficult fault identification in rail transit vehicle bogie axle box bearings under rail service conditions, it is necessary to investigate the acoustic characteristics of these fau...
A Hybrid Power Traction Calculation and Simulation Software with Global Optimization Approach
Objective Optimal design of hybrid power train configuration involves system cost, energy consumption and operation requirements. Therefore, it is necessary to study the hybrid power simulation software with global optim...
Discrete RBF Adaptive Robust Sliding Mode Network Control Method for High-speed Trains
Objective To achieve reliable control of traction and braking key systems in trains while suppressing the impact of communication delay on train control, a discrete RBF (radial basis function) adaptive robust sliding mod...
Research on Station Passenger Flow Organization Model Based on Temporal Knowledge Graph
Objective Urban rail transit stations are facing the challenges of increasing passenger flow pressure and insufficient intelligent means. To improve the efficiency and intelligent level of passenger flow organization in...