Optimization of the Mixing in a Gas-lift Anaerobic Digester of Municipal Wastewater Sludge
Journal Title: Journal of Agricultural Machinery - Year 2024, Vol 14, Issue 1
Abstract
This research aims to optimize the mixing process in gas-lift anaerobic digesters of municipal sewage sludge since mixing and maintaining uniform contact between methanogenic bacteria and nutrients is essential. Wastewater municipal sludge sampling was performed at the Ahvaz West treatment plant (Chonibeh, Iran) during the summer of 2022. A Computational Fluid Dynamics (CFD) model was implemented to simulate, optimize, and confirm the simulation process using ANSYS Fluent software 19.0. The velocity of the inlet-gas into the digester was determined and a draft tube and a conical hanging baffle were added to the digester design. Different inlet-gas velocities were investigated to optimize the mixing in the digester. Furthermore, turbulence kinetic energy and other evaluation indexes related to the sludge particles such as their velocity, velocity gradient, and eddy viscosity were studied. The optimal inlet-gas velocity was determined to be 0.3 ms-1. The simulation results were validated using the Particle Image Velocimetry (PIV) method and the correlation between CFD and PIV contours was statistically sufficient (98.8% at the bottom corner of the digester’s wall). The results showed that the model used for simulating, optimizing, and verifying the simulation process is valid. It can be recommended for gas-lift anaerobic digesters with the following specifications: cylindrical tank with a height-to-diameter ratio of 1.5, draft tube-to-digester diameter ratio of 0.2, draft tube-to-fluid height ratio of 0.75, the conical hanging baffle distance from the fluid level equal to 0.125 of the fluid height, and its outer diameter-to-digester diameter of 2/3.
Authors and Affiliations
D. Baveli Bahmaei,Y. Ajabshirchy,Sh. Abdollahpour,S. Abdanan Mehdizadeh,
Keywords
Related Articles
- EP ID EP731759
- DOI https://doi.org/10.22067/jam.2023.83626.1182
- Views 56
- Downloads 0
Investigation of the Cylinder Liner Wear in Agricultural Tractors
The present study aimed to examine the application of accurate and principle-based evaluation of a measuring instrument called the Form Tester in determining and detecting the wear phenomenon in the cylinder liner of agr...
Optimization of Biogas Production Efficiency from Anaerobic Digestion of Organic Fraction of Municipal Solid Waste under Thermal Pretreatment at Different Concentrations
IntroductionSince anaerobic digestion leads to the recovery of energy and nutrients from waste, it is considered the most sustainable method for treating the organic fraction of municipal solid wastes.However, due to the...
The Effect of Operation and Engine Speed on Chainsaw Vibration
Introduction Tree felling is an important part of forest exploitation. According to the condition of Iranian forests, mechanization in these forests has not been grown as it should be. Therefore, a main part of tree fell...
Vibration Mode for Effective Mechanical Harvesting of Shengy Olive
The main aim of this study was to optimize the design parameters of the fruit shakers for efficient harvesting of Shengy olive. A single-degree-of-freedom spring-mass model was established to determine the natural freque...
A Study of the Shrinkage Changes and Mathematical Modeling of Garlic (Allium sativumL.) During Convective Drying
Garlic (Allium sativumL.) is one of the most important Allium spice. From an economic point of view, the dried garlic slices are valuable products. In this research, garlic slices as a thin layer were dried in a laborato...