Practical Realization Digital PID Controller for Speed Control of DC Motor Using Back-EMF Feedback Method
Journal Title: INTERNATIONAL JOURNAL OF ENGINEERING TRENDS AND TECHNOLOGY - Year 2013, Vol 5, Issue 5
Abstract
This paper describes the speed control of dc motor using back emf method. Among the various techniques for controlling the speed control of dc motor, this method offers relatively simple and cost effective solution. In this method no feedback sensor or extra feedback signal processing circuitry is required. The speed control of dc motor has been achieved using pid controller which is implemented on PIC microcontroller and one method is also proposed to achieve better speed control of dc motor.
Authors and Affiliations
Prof Vishal Vaidya , Prof Kapil Dave , Prof Sandip Mehta
Keywords
Related Articles
- EP ID EP93727
- DOI -
- Views 114
- Downloads 0
Optimization of Cost in Cloud Computing Using OCRP Algorithm
In cloud computing, cloud providers can offer cloud consumers two provisioning plans for computing resources, namely reservation and on-demand plans. Reservation plan is cheaper than that provisioned by on-demand p...
Thermal and Structural Analysis of Disc Brake for Different Cut Patterns
The thermal performance & heat dissipation of brake disc is based on aerodynamic characteristics of flow though brake disc holes. In this project, the cooling performance of two wheeler brake disc is analyzed by usin...
A Typical Assessment Of Photovoltaic Array: Modelling, Simulation and Application Aspects
The paper provides a deep insight into PV array behaviour. The paper provides the information regarding modelling techniques and its simulations. It also presents different installation aspects and power handling...
An Edge Detection Algorithm based on Fuzzy Logic
Edges characterize boundaries and are therefore considered for prime importance in image processing. Edge detection filters out useless data, noise and frequencies while preserving the important structural pro...
Geometry Dependency of Filling Related Defects
During mould filling in casting process, defects such as misrun, cold shut, gas and oxide film entrapment and shrinkage often occur. The development of filling related defects are mainly governed by metal fill...