Prediction of chatter stability in turning
Journal Title: Восточно-Европейский журнал передовых технологий - Year 2019, Vol 5, Issue 1
Abstract
A new technology for predicting chatter in turning, based on simulation of the cutting process in time and frequency domains using the Nyquist diagram has been developed. The cutting process is presented as carried out in an elastic closed-loop technological machining system (TMS), taking into account the machining «by trace». The dynamic model is represented as two-degrees-of-freedom system in the direction of the longitudinal and transverse axes of coordinates. The mathematical model is built in accordance with the system approach, in the form of a block diagram of the connection of elements with transfer functions according to Laplace, is non-linear and has a fourth order. Therefore, the simulation is performed numerically using the fourth-order Runge-Kutta procedure. It is shown that when studying chatter, three groups of factors should be taken into account: tool geometry, dynamic parameters and cutting mode, which should be represented as an analogue of the material removal rate. The dynamic parameters of the system are obtained by processing the experimental weight characteristics obtained by striking the system with a special hammer. An application program that allows simulation of the process of regenerative oscillations occurrence in time domain and building the amplitude-phase characteristic of TMS in cutting has been created. The application program performs modeling based on the source data of the cutting conditions and dynamic characteristics of the system. Dynamic characteristics of the system are presented in the form of stiffness and frequency of the main harmonic along the corresponding coordinate axes. The simulation showed that the results completely coincide with the frequency analysis results of the profilogram of the actually machined part that allow recommending this technology for predicting and evaluating chatter and stability in turning
Authors and Affiliations
Yuriy Petrakov, Mariia Danylchenko, Andrii Petryshyn
Keywords
Related Articles
- EP ID EP664144
- DOI 10.15587/1729-4061.2019.177291
- Views 62
- Downloads 0
Substantiation of parameters for the technological process of restoring machine parts by the method of plastic deformation
<p>We have studied technological processes related to the restoration of worn-out parts of agricultural machinery (plowshares, cultivator sweeps) that operate under conditions of intensive abrasive wear. We have determin...
Studying the effect of the combined technology on durability of the shafttype parts
<p>Restoration of shaft parts with extending their service life is an important reserve of development and growth of repair efficiency. Improvement of wear resistance and durability of parts of agricultural machinery is...
Calculation of stress concentrations in orthotropic cylindrical shells with holes on the basis of a variational method
<p>A variational numerical-analytical method (called the RVR method) is suggested for calculating the strength and stiffness of statically loaded non-thin orthotropic shell structures weakened by holes (stress concentrat...
Testing of measurement instrument software on the national level
<p class="Default">Features of software for measuring instruments are considered. A comparative analysis of the general requirements in the documents and guidelines of the international and regional organizations of legi...
Substantiation of parameters and operational modes of air solar collector
<p>We developed a new design of an air solar collector for a fruit dryer including double glazing and a selective surface made of a thin metal substrate with inlet and outlet openings on its bottom. We established that i...