Preparation of Zeolite Catalyst using Fly Ash for Catalytic Reduction of S. I Engine
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2019, Vol 9, Issue 5
Abstract
In this paper we had prepared Zeolite from low cost coal fly ash. In this paper, Na-X Zeolite like component was manufactured from the fly ash remains of the coal. The present traditional three ways exhaust system utilized in fuel motors controls successfully the degrees of CO and HC yet it shows poor transformation in unsafe NOx outflow. The exhaust system is manufactured and the experimental tests are performed at the most extreme motor RPM to obtain threshold emission reduction value. The outcomes indicated the decrease of CO2 at a lower cost. Besides, it is discovered that utilizing Zeolite sieves can further decrease the toxin emanation at a comparative expense and utilizing glass wool to make a muffler for the exhaust.
Authors and Affiliations
Shubham Upadhyaya, Divyam Raj
Keywords
Related Articles
- EP ID EP671634
- DOI 10.24247/ijmperdoct20197
- Views 91
- Downloads 0
THERMO-MECHANICAL ANALYSIS OF HIGH TEMPERATURE INSULATING COMPOSITES
The investigation highlights the influence of C-ph and C-ph-BN with different volume fractions and the densities of carbon phenolic with 30 – 70 Vf, finding thermal conductivity,Specific heat and the thermal diffusivity...
An Experimental Investigation on Diesel Engine Performance using Moringa Olifera Biodiesel with the Effect of Different Injection Pressures
Increasing cost of petroleum diesel and environmental degradation due to automotive pollution, forces the researchers to search an alternate fuel like biofuel and biodiesel for diesel engine. The biodiesel is produced fr...
Two-Dimensional Simulation to Investigate the Interaction of Fluid - Structure Inside A Microchannel with Elastic and Rigid Boundary
In this paper, shape change of the elastic and rigid boundary in a micro-channel is simulated. The rings are considered as elastic boundaries immersed in the fluid flow. In this study, we use the Immersed Interface Metho...
A Review on Non-Circular Journal Bearings
Hydrodynamic bearings depend on the high journal speed to move the pressurized fluid in a wedge between the faces. Instabilities due to oil whip and whirl are usually observed when using hydrodynamic circular journal bea...
An Effect of Ball Milling on Microstructural Parameters of Nanostructured MoO3-CuO-V2O5 Composite Nanopowders
The present work meant to look at the impact of crystalline size, lattice strain and dislocation density of ultrafine thermally excelledMoO3, MoO3-CuO and MoO3-V2O5 composite nanopowders utilizing mechanochemical milling...