Pressure Surge Analysis of a Test Bench for Biodegradable Hydraulic Oils
Journal Title: Tribology in Industry - Year 2018, Vol 40, Issue 2
Abstract
A test bench for biodegradable hydraulic oils generates pressure surges by cyclic pressure loading. The parameters of these pressure surges (maximum pressure, amplitude, frequency etc.) are defined by the characteristics of the pressure valve and pipe line system. The response of the hydraulic system was recorded and studied in the case of four test bench modifications by comparing the maximum pressure, maximum pressure increase and the opening time of the pressure valve. The test bench with steel pipe between the hydraulic pump and pressure valve shows the highest maximum pressure increase (4.28 MPa). The opening times of pressure valve were measured for the evaluation of dynamic stability of the test bench. In case of all test bench modifications the opening time of pressure valve did not exceed the calculated limit value. The experiments were also aimed at the response of hydraulic system to three different frequencies (1.5 Hz, 2.5 Hz and 5 Hz) of cyclic pressure loading. Increasing the frequency only minimally increases the maximum pressure during the pressure surge. On the other hand, it increases maximum amplitude after the maximum pressure depending up to frequency of cyclic pressure loading. Fast Fourier Transform (FFT) confirms the facts mention above.
Authors and Affiliations
R. Majdan, M. Olejár, V. Šarac, D. Uhrinová, J. Nosian
Keywords
Related Articles
- EP ID EP293362
- DOI 10.24874/ti.2018.40.02.02
- Views 111
- Downloads 0
Investigation of Wear Pattern in Piston Ring of an IC Engine
Piston Ring, as small as it appears, plays quite an important role in contribution to friction and wear in an IC engine. As a first approximation most wear models, have quantified wear of a piston ring in terms of total...
[sup][/sup][sup][/sup][sup][/sup]Development of Polyester/Eggshell Particulate Composites
The development of Polyester/Eggshell particulate composites has been carried out. Uncarbonized and carbonized eggshell particles were used as reinforcement in polyester matrix. 10 to 50 wt% eggshell particles at interv...
Sliding Tribological Behavior of Carbon Nanotube/Natural Rubber Composites
A computational study has been made to investigate the tribological properties of carbon nanotube reinforced natural rubber composites as a function of sliding velocity at a normal loading. A three-layer model in which t...
Development of Zn50 Brazing Alloy for Joining Mild Steel to Mild Steel (SAE1018)
This work has developed new brazing alloys for joining mild steel to mild steel (SAE1018) at a lower temperature. The alloys blends and error analysis were done by experimental design software (Design Expert 8.0.7.1). De...
Influence of Load and Sliding Speed on Friction Coefficient of IBAD Deposited TiN
The influence of applied load and sliding speed on the tribological performance, i.e. friction and wear of TiN IBAD coating in sliding with corundum ball has been evaluated using reciprocating sliding wear test. Post cha...