Results of studying the Cu/ITO transparent back contacts for solar cells SnO2:F/CdS/CdTe/Cu/ITO
Journal Title: Восточно-Европейский журнал передовых технологий - Year 2018, Vol 4, Issue 5
Abstract
<p>We have studied transparent rear contacts Cu/ITO for the CdTe-based solar cells intended to be used in tandem and two-side sensitive instrumental structures. Creating an ohmic contact to the base layers of p-CdTe under industrial production is not practical as only platinum has the work function of electrons required for forming the ohmic transition. That is why the tunnel contacts are typically formed, using the thin films containing copper or copper chalcogenides. However, the diffusion of copper into the base layer leads to the degradation of initial parameters of film solar cells based on CdS/CdTe. Therefore, conditions for creating the transparent rear contacts when using a layer of copper require examination. It was established that the preliminary application of a nanodimensional layer of copper on the CdTe surface in order to form a rear electrode allows the formation of a quality tunneling contact. It is shown that the obtained instrumental structures demonstrate high degradation resistance. After 8 years of operation, the magnitude of efficiency for the examined PEC is nearly identical to the initial value. Studying the light volt-ampere characteristics of the SnO<sub>2</sub>:F/CdS/CdTe/Cu/ITO solar cells when illuminated from both sides allowed us to establish significant differences between the initial parameters and the light diode characteristics at illumination from a glass substrate and from the rear transparent electrode.</p><p>The established differences are due to the influence of a rear diode on the efficiency of photovoltaic processes in the base layer. The examined structure implements an inverse diode regime when a rear contact represents a diode, connected in series relative to the principal diode, which leads to the lower values of efficiency at illumination from the rear electrode. The results obtained demonstrate the need to reduce the thickness of the base layer in order to create effective two-side sensitive elements.</p>
Authors and Affiliations
Natalya Deyneko, Oleg Semkiv, Olexander Soshinsky, Victor Streletc, Roman Shevchenko
Keywords
Related Articles
- EP ID EP528077
- DOI 10.15587/1729-4061.2018.139867
- Views 72
- Downloads 0
Analytical estimation of inertial properties of the curved rotating section in a drill string
<p>We have proposed approaches to analytical assessment of the moment of inertia related to the curved rotary sections in a drill string. Research into rotation processes of the curvilinear sections in a drill string is...
Transformation of operations with fuzzy sets for solving the problems on optimal motion of crewless unmanned vehicles
<p>Solution of an optimization problem of the minimum time of motion of the crewless and unmanned aerial vehicle (CUV) was stated and analyzed. A connection was established between projections of the velocity vector as a...
Improvement of cavitation erosion characteristics of the centrifugal inducer stage with the inducer bush
<p>The impact of the inducer bush, which is a stator bush with longitudinal straight grooves installed over the inducer in the model centrifugal stage on its performance, was studied. A physical experiment was performed...
Analysis of probabilities of differentials for block cipher “Kalyna” (DSTU 7624:2014)
<p class="a"><span lang="EN-US">The adaptation and application of the method for estimating the upper bound of the probability of tworound differentials for the block symmetric cipher Kalyna is carried out. This cipher...
Development of a method for optimization calculation of a group of sound-insulating panels for airborn noise protection
<p>Various designs and procedures for calculating soundproof panels for protecting premises against airborne noise were considered. These procedures make it possible to calculate single-layer, two-layer and three-layer p...