Silumins alloy crystallization
Journal Title: Archiwum Odlewnictwa - Year 2009, Vol 9, Issue 3
Abstract
This paper presents the results of research, by ATD method, of hypo-, near- and hyperutectic silumins crystallization containing the following alloying additives: Mg, Ni, Cu, Cr, Mo, W, V. It has been shown that, depending on their concentration may crystallize pre-eutectic or eutectic multicomponent phases containing these alloy additives. It has been revealed that any subsequent crystallizable phase nucleate and grows near the liquid/former crystallized phase interface. In multiphases compound also falls the silicon, resulting in a reduction in its quantity and the fragmentation in the eutectic mixture. As a result, it gets a high hardness of silumins in terms of 110-220HB.
Authors and Affiliations
S. Pietrowski, T. Szymczak
Keywords
Related Articles
- EP ID EP72023
- DOI -
- Views 109
- Downloads 0
Influence of pressure mould material on the durability of coating a thermal and anti-erosion barrier
This study presents the research results of the durability of coating (thermal and anti-erosion barrier) of a mincer cap casting pressure mould. Tests were conducted with the use of an IDRA OL320 pressure machine. Durabi...
The estimation of ability to reclame of moduling sands with biopolymer binders
Applied up till now organic binding materials, on the basis of synthetic resins are characterised by good technological properties, but cause high emission of harmful substances. That’s why contemporary scientific resear...
Effect of overheating degree on the solidification parameters of AlSi17CuNiMg silumin
Melting technology, especially the temperature of overheating and pouring above the liquidus point Tliq as well as the cooling rate, determine alloy macro - and microstructure, and hence also casting performance proper...
Examples of material solutions in bimetallic layered castings
In paper is presented technology of bimetallic layered castings based on founding method of layer coating directly in cast process so-called method of mould cavity preparation. Prepared castings consist two fundamental p...
Model of knowledge representation about materials in the form of a relational database for CAPCAST system
This study is related with one of the components of a hybrid decision support system called CAPCAST, implemented under a research project conducted by WIMIIP AGH. It is a model of knowledge representation about materials...