Solar Power Plant Design Using Automatic Transfer Switch on PLN-PLTS Network
Journal Title: Engineering and Technology Journal - Year 2024, Vol 9, Issue 07
Abstract
Solar power plants are conventional generators, solar power is often in demand by the public in general, but the use of solar power plants experiences several problems, such as batteries that are easily damaged. This is because the use of the battery exceeds the depth of discharge. This study designed a PLTS using an Automatic Transfer Switch with a solar panel capacity of 20 Wp using a quantitative method. The results of this study in the first test the light intensity income at 10.00 was 28803 lux with a maximum power of 9.22 Watt and a charging power of 7.02 Watt, then at 11.00 the light intensity increased by 54733 lux followed by a power of 8.80 Watt with a charging power of 7.15 Watts. So the conclusion of this study is that the greater the intensity of the light produced, the higher the output power.
Authors and Affiliations
Slamet Han , Gatot Santoso , Joko Susetyo ,Alfi Hadi Permana,
Keywords
Related Articles
- EP ID EP740775
- DOI 10.47191/etj/v9i07.23
- Views 41
- Downloads 0
The Absorbent Capabilities of Soil in Structural Works Are Related to the Quality of the Concrete
In implementing building construction from low level to middle level, if the implementation is not using the services of a supervisory consultant, the implementers sometimes do not pay attention to the rules in the imple...
Technologıcal Methods of Increasıng Bearıng Performance
The tribological characteristics of bearing shells manufactured using various technologies have been studied. The results obtained allow us to determine the most technologically advanced method. One of the main requireme...
Single and Double Drop Impingement on a Heated Plate CFD and Experimental Investigation
A drop impingement on a hot surface is known as an effective way for heat removal. The present work uses a VOF (volume of fluid) model to simulate the flow behavior and temperature distribution on a 50 °C heated plate wh...
IDENTIFICATION OF THE DISTRIBUTION OF MUZZLE VELOCITY AND MAXIMUM PRESSURE IN THE BARREL FOR A TYPICAL RIFLE
The paper presents the procedure for identifying the distribution of muzzle velocity and the maximum pressure in the barrel for a typical 7.62mm rifle. Input data are collected through the experiment using 50 shots for m...
Development of Interactive Learning Media Based on the Aleis (ATC Licensce Exam Information System) Website for Air Traffic Controllers at Makassar Aviation Polytechnic
The Air Traffic Management study program has graduate learning outcomes level 5 SKKNI flight traffic guides and Aeronautical information lighting, graduate learning outcomes are realized in the issuance of licenses teste...