Spray Characteristics Optimization of Biodiesel Fuel in Constant Volume Chamber Using Multi-Response Optimization Technique
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2019, Vol 9, Issue 4
Abstract
This study primarily focuses on optimizing the spray characteristics of biodiesel fuel in a spray chamber. Three factors have been considered; fuel injection pressure, number of nozzle holes and fuel blends. To achieve this objective, these were chosen as the factors (injection pressure, number of nozzle holes, fuel blends). Three levels were chosen as the response variable namely, Spray penetration length (S), Spray angle (ϴ) and Sauter mean diameter (SMD). These investigaten were done with the aid of Taguchi full factorial array method.To calculate the response variables, theMulti Response Signal to Noise Ratio (MRSN) technique was used. To find optimum combination level of factors, the Taguchi’s parametric design were exploited.
Authors and Affiliations
B. Yoneshwar, C. Raj Kishore,, K. Vishnu, P. Raghu
Keywords
Related Articles
- EP ID EP656894
- DOI 10.24247/ijmperdaug2019116
- Views 119
- Downloads 0
THE COMPARISON OF DEVIATIONS OF FREEFORM SURFACES USING RE-ENGINEERING BY NON-CONTACT SCANNERS
There are various types of optical and Laser 3D scanners used for capturing the point cloud data in reverse engineering approach. The present article deals with the comparison of EINSCAN Scanner and the V5 PERCEPTRON 3D...
Effect of Polyacrylamide with ZnO Nano Aqueous Solution on the Chemical Flooding Method with Enhanced Oil Recovery EOR) – An Experimental and Modelling Study
This work studied the effect of polyacrylamide (PAM) with ZnO nanoparticles (NPs) solution on the recovery of crude oil in tertiary stage. Shear viscosity due to shear rate and salt concentration, also shear stress with...
Grain Refinement through Design Modification of ECAP Dies
The need for super-plasticity and high strength leads to the development of Severe Plastic Deformation (SPD) techniques. The strength of the material is directly dependent upon the grain size of the material. During the...
Effect of Sintering Temperature on Mechanical Properties of Mg-Zr Alloy
Magnesium, Zirconium alloy is developed in three different sintering temperatures through powder metallurgy technique followed by hot extrusion in this work. The application of this material is for orthopedic implants. M...
EFFECTS OF WATER DIESEL EMULSION ON DIESEL ENGINE
The Water Diesel Emulsion (WiDE) fuel shows nepotism in terms of environmental and economical aspects. In the present investigation, WiDE is used as fuel for the diesel engine. Here, WiDE was prepared with various water...