Static and dynamic tensile characteristics of DP600 steel sheets
Journal Title: Materials Engineering - Materialove inzinierstvo (MEMI) - Year 2014, Vol 21, Issue 1
Abstract
Dynamic tensile testing of sheet steels is becoming more important. Experimental dynamic tensile technique is depending on the strain rate. Each serves for a specific range of strain rates and provides specific type of information. For experiments was used two testing method servo hydraulic and single bar method. Experiments were realized on steel grade DP 600. DP-type steels are low-carbonsteels with soft ferrite and hard martensite. Steel were performed and evaluated static and dynamic tests. Substructure was investigated in static and dynamic loading conditions.
Authors and Affiliations
Miroslav Német, Mária Miháliková, Vladimír Girman
Keywords
Related Articles
- EP ID EP131337
- DOI -
- Views 105
- Downloads 0
IMPACT STRENGTH AND FAILURE ANALYSIS OF WELDED DAMASCUS STEEL
The aim of this work was the experimental research of damascus steel from point of view of the structural analyze, impact strength and failure analyzes. The damascus steel was produced by method of forged welding from ST...
INFLUENCE OF SHOT PEENING ON AISI 316Ti FATIGUE PROPERTIES
This paper deals with examination of fatigue properties of AISI 316Ti stainless steel before and after shot peening including analysis of residual stress relaxation during rotating bending fatigue tests (f = 50 Hz, T = 2...
USING THE VIDEOEXTENSOMETRY AND UCI - HARDNESS FOR MONITORING OF AUTOMOTIVE STEEL SHEETS
The paper deals with examination of relation between the hardness and the size of plastic zone during the tensile loading. UCI (Ultrasonic Contact Impedance) micro-hardness method was used for hardness measurements. Defo...
THE QUALITY OF MATERIALS APPLIED FOR SLEWING BEARING RACEWAY – TECHNICAL PAPER
Selected slewing bearings and their application have been described in this article. Basic causes of the damage pitch surfaces of slewing bearings have been analyzed and examples of the damage have been presented as well...
The effect of different shot peening intensities on fatigue life of AW 7075 aluminium alloy
In this study the effect of different shot peening intensities, from very light peening with ceramic beads to severe shot peening with high coverage, on the fatigue life of aircraft AW 7075 aluminium alloy was investigat...