Study of Corrosion behaviour on Tig and Friction Stir Welded Joints of AA6061-T4
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2018, Vol 8, Issue 2
Abstract
Aluminium alloy 6061, treated with T4 condition of thickness 4mm were butt welded by Friction Stir Welding (FSW) and Tungsten inert gas welded (TIG) method. Process parameter decides the quality of weld in FSW and TIG method. Friction Stir Welding is done by varying the speed of rotation of tool and speed of the welding with constant axial load of 8KN. GTAW is done by varying current with ER4346 filler material. The welded joints are tested for its corrosion rate in Potentiostat with 3.5% Nacl solution. The corrosion behavior of welded joints was probed by Tafel polarization curve. This technique uses data obtained from cathodic and anodic polarization measurement. Tafel plots provide the direct measure of the corrosion current, which canbe related to corrosion rates. The result shows that FSW at 1200rpm has the higher corrosion resistance, comparatively
Authors and Affiliations
Keywords
Related Articles
- EP ID EP347642
- DOI 10.24247/ijmperdapr2018105
- Views 98
- Downloads 0
ANALYSIS AND EVALUATION OF MACHINING RESPONSES DURING HARD TURNING OF EN353 STEEL
Estimation, prediction and analysis of responses in turning operation is one of the key research areas. This paper studies the performance of coated inserts (PVD and CVD) in hard machining. In this analysis, 27sets of ha...
Model Order Reduction and Linear Quadratic Regulator Controller Design on A Large Scale Linear Time Invariant System
The main objective of this paper, aims to apply model order reduction on a large scale system and design a Linear Quadratic Regulator (LQR) based controller, to analyse the performance indices, in the time and frequency...
Design of Low Power and Area Efficient Full Adder for ALU Using 90nm Process for Industrial Based CAD/CAM Manufacturing Units
The research article shows a high accuracy of full adder with less zone and power utilization. The GDI based full adder wasactualized by utilizing both entryway dispersion through input gate diffusion system and rational...
Investigating the Effect of the Various Stiffness Coefficient on the Controlled Damper Mass Spring System Based on the Electromechanical Sensor
This work is concerned with investigation the effect of the stiffness coefficient for the spring elements in the mechatronics applied system consists of damper mass spring system linked to the electrical position sensor....
Kalman Filter based Fault Detection and Replacement Signal Generation of Sensor Measurements in Cement Rotary Kiln
Replacement of faulty sensor signals in a cement kiln is a challenging problem in fault diagnosis due to the increasing demand of fault- free feedback signal to the controller in order to produce good quality cement and...