Study on Breaking Load of Single Lap Joint Using Hybrid Joining Techniques for Alloy Steel AISI 4140 and Mild Steel: Taguchi and Neural Network Approach
Journal Title: Strojnicky casopis - Journal of Mechanical Engineering - Year 2018, Vol 68, Issue 1
Abstract
The present investigation carried out to analyze the breaking load of single lap joint using hybrid joining techniques for alloy steel AISI 4140 and mild steel as base material by experimentally and optimized by Taguchi method and neural network. The six samples of lap joints were prepared namely: bolted joint (BJ); adhesive joint (AJ); welded joint (WJ); bolted-welded joint (BWJ); adhesive-welded joint (AWJ) and adhesivebolted joint (ABJ). The breaking load of the joints in terms of breaking load and elongation were evaluated for each joint. The effect of the adjustment attached to the joint on the breaking load and elongation were evaluated. Taguchi method was applied for given input parameters and L4 design of experiments was used. The breaking load and elongation were taken as output response. The predicted values by Taguchi method were used as target values in neural network fitting curve. Neural network fitting tool was used to check whether the obtained values were near the target value or not. Based on the achieved results, the maximum breaking load and elongation were found for bolted-welded joint.
Authors and Affiliations
Prasad Lalta and Khantwal Rahul
Keywords
Related Articles
- EP ID EP43927
- DOI https://doi.org/10.2478/scjme-2018-0005
- Views 189
- Downloads 0
THE INFLUENCE OF MATERIAL ON THE OPERATIONAL CHARACTERISTICS OF SPUR GEARS MANUFACTURED BY THE 3D PRINTING TECHNOLOGY
The advanced development of additive technologies over the past years led to the fact that parts made by these technologies have been increasingly used in the most diverse engineering applications. One of the most famo...
Suitability Assessment of Two Types of Heat Exchangers for High Temperature, Naturally Circulating Helium Cooling Loop
The paper presents a comparison of the process properties of two types of the heat exchangers designed for the heat removal from a high temperature helium cooling loop with steady natural circulation of helium. The fir...
Analysis of Pharmaceutical Excipient MCC Avicel PH102 Using Compaction Equations
This paper focuses on the characterization of the tabletting process and analysis one of the most common pharmaceutical excipients MCC Avicel PH102 by Heckel, Kawakita, Cooper-Eaton and Adams compaction equations. Expe...
The Calculation of the Contact Force and the Contact Width of Shaft Seals
The aim of the article is to point out the sealing efficiency of the two-language seal of the water pump bearing when radially deflecting the shaft within radial clearance. In order to obtain a radial displacement of th...
Modeling of Coolant Flow Within the Spent Fuel Storage Pool of a VVER 440 Reactor
The article deals with modelling of coolant flow within the spent fuel storage pool of a VVER 440 reactor. The spent fuel storage pool is modelled in a state of standard reactor operation. The coolant heating from the...