Studying the influence of design and operation mode parameters on efficiency of the systems of biochemical purification of emissions
Journal Title: Восточно-Европейский журнал передовых технологий - Year 2018, Vol 3, Issue 10
Abstract
<p>A procedure for evaluating efficiency of the systems of biological elimination of soluble and insoluble in water harmful gaseous substances as well as dissolved in water contaminants has been devised. The procedure is based on previously developed mathematical models of the corresponding non-stationary bio oxidation processes. Based on the analysis of 27 design versions, real capabilities of biological purification facilities were shown, the effect of design and operation mode parameters on efficiency of the systems of biological destruction of methane, hydrogen sulfide and formaldehyde were assessed. In quantitative terms, the results obtained in numerical experiments indicate the necessity of taking into account variation of the rate of pollutant inflow in the process of vessel filling. It was established that an increase in the facility efficiency in terms of the volume of the gas-air mixture, N, causes a decrease in methane concentration at the bioreactor entry and a reduction of the purification degree to 62 %. An increase in the rate of hydrogen sulfide inflow to the reactor leads to a reduction of the purification degree from 98 to 95 %. An increase in the initial concentration of biomass by a factor of 1.7 causes a decrease in concentration of hydrogen sulfide in water from 2.5 to 1.1 g/m<sup>3</sup>. A significant decrease in the average specific bio oxidative power with an increase in the working space in which the final stage of emission purification from formaldehyde takes place was also observed.</p><p>The revealed regularities represent a tool for improving quality of design solutions and increasing effectiveness of bio oxidation modes in operation of the systems of biological gas purification.</p>
Authors and Affiliations
Anna Bakharevа, Oleksii Shestopalov, Olesya Filenko, Tetyana Tykhomyrova, Olga Rybalova, Sergey Artemiev, Olena Bryhada
Keywords
Related Articles
- EP ID EP528027
- DOI 10.15587/1729-4061.2018.133316
- Views 74
- Downloads 0
Determining the motion character of loose materials in the system of continuous action «hopper – reciprocating plate feeder»
<p>This paper reports methods for modeling the movement of bulk material in dispensing equipment of continuous action. It was established that modeling the pulsations and fractures in the flow of bulk material can be per...
Results of research into technological process of fruit drying in the solar dryer
<p class="2CxSpFirst">The work addresses the issue of solving a scientific-applied task on the substantiation of operation modes of the solar fruit dryer in order to improve energy efficiency of the technological process...
Modeling of dynamic stability of the well deepening process based on the catastrophe theory
<p>Theoretical aspects of the catastrophe theory were considered and the possibility of application of the catastrophe theory methods in estimation of actual data of geological and technical control of the well deepening...
Development of trenchless technology of reconstruction of «pulling pig P» pipeline communications
<p>The technology of trenchless reconstruction of pipeline communications has been developed by pulling a new polyethylene pipeline into a worn-out steel traction by the pig. The pig moves under the pressure of air suppl...
Visualization of bubbles formation on the boiling process in tapering heat pipe with variation of evaporator to condenser diameter ratio
<p class="MDPI17abstract">In the present study, a new tapering heat pipe design had been developed to enhance the thermal performances. Boiling visualization in the tapering heat pipe is investigated to provide the detai...